Models > DPSR483EA1WW > Parts

DPSR483EA1WW General Electric Dryer - Parts

All parts for the General Electric Dryer DPSR483EA1WW

Below is a list of all parts for the General Electric Dryer DPSR483EA1WW - Electric . To find the repair part you need, you can browse the list below or you can narrow your choices by searching for a part by name or description.

All Parts for the DPSR483EA1WW
1-14 of 93
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?

Drum Bearing Slide - White

Sold individually. There are 2 per dryer. They attach to the outer-most sides of the bearing. Manufacture recommends to replace both slides at the same time.


Timer Knob

This dryer knob accepts a D-shaped shaft.


Duct Felt Seal

May differ in appearance but functions same as original.


D-Shaped Knob Insert Clip

Sold individually.


Front Drum Bearing

Note: The drum slides should also be replaced when your replacing the drum bearing. Slides are NOT included. This part helps your dryer operate as quietly as possible.


Drive Belt

This drive belt is 89.5" long.


Lint Filter and Frame

This filter collects lint as it passes through the dryer vent.


Rear Drum Bearing Kit

This rear drum bearing kit comes with a shaft, bearing and installation instructions. The bearing plate comes with a slot in it for the ground strap. Helps keep your dryer running as smoothly as possible with as little noise as possible.


Door Handle - White

This part is on the outer door of the dryer.


Interlock Switch

This part is a simple on/off mechanism that prohibits the appliance from operating when the door is open.


Knob and Clip

This knob accepts a D-shaped shaft.


Idler Pulley Wheel

A dryer's idler pulley wheel serves to help the belt to rotate the drum.


Rotary Start Switch

This part is used to start the dryer once you have selected a setting on the timer.


Cycling Thermostat - 4 Wire

This thermostat helps to regulate the dryer's internal temperature. L210-30F

All Parts for the DPSR483EA1WW
1-14 of 93