Models > DPSR483EA1WW

DPSR483EA1WW General Electric Dryer - Overview

Get Parts and Repair Help for DPSR483EA1WW

If you know the dryer repair part you need, you can browse the list of all parts on the DPSR483EA1WW, or you can search by name or part description. You can also find your part by where it is located on the DPSR483EA1WW by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your dryer. We’ve also included any installation videos we have for DPSR483EA1WW parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the DPSR483EA1WW [Viewing 4 of 4]

$6.92

Drum Bearing Slide - White

Sold individually. There are 2 per dryer. They attach to the outer-most sides of the bearing. Manufacture recommends to replace both slides at the same time.

$18.13

Front Drum Bearing

Slides are NOT included. This part helps your dryer operate as quietly as possible. Note: The drum slides should also be replaced when your replacing the drum bearing.

$13.77

Timer Knob

This dryer knob accepts a D-shaped shaft.

$3.62

D-Shaped Knob Insert Clip

Sold individually.

$19.98

Drive Belt

This drive belt is 89.5" long.

$46.29

Rear Drum Bearing Kit

This rear drum bearing kit comes with a shaft, bearing and installation instructions. The bearing plate comes with a slot in it for the ground strap. Helps keep your dryer running as smoothly as possible with as little noise as possible.

$29.49

Lint Filter and Frame

$3.21

HANDLE DOOR

$14.88

Idler Pulley Wheel

A dryer's idler pulley wheel serves to help the belt to rotate the drum.

$26.67

Rotary Start Switch

This part is used to start the dryer once you have selected a setting on the timer.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Timer knob cracked and would not turn on the dryer

  • Customer: Kathleen from Greenwood IN
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 142 of 207 people found this instruction helpful
Very easy. I just snapped the new timer knob on and I was ready to go. read more

original duct was broken

  • Customer: Chad from Gilbert SC
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers
  • 85 of 91 people found this instruction helpful
Dear PartSelect.com,

My repair went off without a hitch.

2 screws removed to remove top.
4 screws removed from inside to remove front panel w/ door.
4 screws removed from top of control panel, loosed and popped top right off.
Flathead screwdriver to pop off old plastic panel.
Removed old wire chase (plastic, approx 3... read more

Heater element went out

  • Customer: Brian from Clinton MO
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 87 of 105 people found this instruction helpful
First of all, unplug the dryer. I removed the two screws on the front of the cabinet to remove the top. I then took out the screws to remove the dial panel. Release the belt for the drum through the access hole in the rear of the dryer. Remove the front cover and pull the drum assembly out.

Remove the element disc from the rear of the housing... read more