DCD330EY0AC General Electric Dryer - Instructions

Turned off dryer breaker!!Pryed dryer top up and off using flat blade screwdriver, removed two philips head screws inside and top, rermoved wires for door switch. I pulled off the old drum slide and lower felt. I scraped the large left overs and used some solvent to clean the remaining fuzz. I glued the felt and slide per the instructions, applied the new parts. I waited about 30 minutes and assembled, it did make a squeaking noise for about 2 minutes. When everything seated in the noise was gone. $150.00 and simple mechanics saved me from spending more on a new dryer, mine is 15 yrs old.

Scared to do the work myself found this website which gave me basic instructions and access to parts needed. Ordered and made an error called and CS took care of me right away. Fast friendly and will buy from them again. Great service great parts and great people!

Top control panel removed; next used screwdriver to lift up dryer top on each side( the top of dryer is attached by clips on the underside) the dryer front panel has two screws, one on each side of inside front(they are easy to reach and near the top of the inside front panel, after removing these two screws we used screwdriver again to pry off front panel as it is attached also by clips on inside of front panel. At this point there is easy access to the drum where the old belt was removed, new belt put in place; removed small panel on back of dryer to access idler pulley and attached new belt through the pulley; turned the drum a couple of times by hand to check if belt was running true on the drum; problem fixed.

very simple my husband put it on in no time