Models > CVG4380PD > Instructions

CVG4380PD Jenn-Air Cooktop - Instructions

All Instructions for the CVG4380PD
61 - 63 of 63
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Burner was not lighting
I removed the pan and then the burner assembly. Used a nutdriver to remove the old front burner. Replaced with the new part, tightened it on, and tested the new burner. Worked first time. Extremely easy. It took less than 5 minutes to replace.
Parts Used:
Front Burner Assembly - Black (Glossy Finish)
  • Luciano from Hollister, CA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Nutdriver
Was this instruction helpful to you?
Thank you for voting!
Filter worn out, exhasut fan kept going off
Old filter allowed too much air flow causing exhaust fan to go off....installed new filter in exhaust chamber...release clip on old filter and install new filter (at an angle) in the exhaust box....clamp down clip on edge of filter and job is complete
Parts Used:
Grease Filter
  • John from Cayce, SC
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
rear burner not working
removed two hexigon screws--removed old burner---placed new burner into stove socket--replaced two screws. Done in about five minutes. Most time used to fine right size socket to fit screws! Fast delivery--easy repair--AND it works!
Parts Used:
Rear Burner
  • Larry from Washington, NH
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Socket set
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the CVG4380PD
61 - 63 of 63
Back to Top