Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
light in freezer section not working
Using plyers Pulled old switch down and out. Put new one in and pushed new switch up into position. The switch plugs into the contacts, no wiring needed. Worked like a charm. You saved me 200 dollars GE repair bill. Thanks
all I had to do is remove the broken cover then replace the new one which only took about 2 minutes. It was so easy and it is a little more durable than the original one.
Removed the old pan cover, which lifts out very easily, and replaced with the new one. I had to install the two plastic washers, that came with the kit, at the bottom of the refrigerator door around the hinge pin. To avoid having to take the door off to install the washers, I cut a piece out of each washer big enough to fit onto the hinge pin. I first lifted the door up and placed a support underneath and then I snapped the washers onto the pin. This was done so the door would close properly. Installation instructions were enclosed with the shippment. Installation was less than 15 mins.
I took out the old cover and slid the new one in place. Unbeievably easy. The old cracked cover was palpably a poorer-quality item than the replacement. The box from PartSelect also included some rubber washers in case the new cover impeded door closing, but it did not. Thank you very much, PartSelect!
1) This is a built-in refrigerator with the compressor, coils, etc. at the top. Turn off the breaker to the fridge. 2) Remove the front panel off the top (just push up and pull out). 3) Removed 2 screws to the old timer and carefully remove the plug. Plug the new timer in and screw in. 4) Since our fridge was heavily frosted up, we moved everything to another refrigerator and coolers and kept the refrigerator off until all panels were room temperature. 5) If you haven't cleaned the coil in a while, vacuum it with a soft brush attachment. 6) Turned back on and the refrigerator is cooler than ever!
Cracked shelf when using as an assist to stand up after cleaning
Super easy, removed drawers, lifted shelf and pulled out. Reversed the process with the new one and ready for use. Found new shelf to be a more sturdy quality than factory install so should have done this replacement years ago when I cracked the shelf! Excellent service in matter of just few days to get product. Would recommend highly.
I took it right out of the framed box to keep the gasket in shape and snapped it back on the gasket mount on the freezer door it took 5 minutes or less perfect fit
took out the old one and slid in the new, it worked. It took about 3 mins. and now I have a much more efficient bottom shelf in my refrigerator. Thanks!