310869-1-S-GE-WR9X502           -Defrost Timer - 120V 60Hz
310869-1-S-GE-WR9X502           -Defrost Timer - 120V 60Hz 310869-2-S-GE-WR9X502           -Defrost Timer - 120V 60Hz 310869-3-S-GE-WR9X502           -Defrost Timer - 120V 60Hz http://www.partselect.com/Schematics/GE/00119164i04.gif

Defrost Timer - 120V 60Hz

PartSelect Number PS310869

This defrost timer will cycle for twenty-five minutes after every six hours of run time. The timer itself is made of plastic, and its terminals are bent, the leads are internal, and the label is orange.

This part works with the following brands: GE, Hotpoint & Kenmore.

This part fixes the following symptoms:

  • Fridge too warm.
  • Freezer section too warm.
  • Freezer not defrosting.
  • Leaking.
  • Fridge runs too long.
  • Freezer too cold.
  • Compare At

    $64.78
  • You Save

    $10.80
  • Your Price

    $53.98
In Stock
Fast Shipping Get this part fast. Average delivery time via regular ground: 1.8 days.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 3.9 / 5.0, 11 reviews What's this?
1-5 of 11
 

54 of 86 people found this instruction helpful

Parts Used:
  • Defrost Timer - 120V 60Hz
Level of Difficulty: Easy
Time to do repair: Less than 15 mins
Tools: Nutdriver
Customer: Nancy from Hamburg, NY

Display showed de

popped off front grille, removed 2 screws for bracket, then had to remove one screw for timer. unplugged old timer, reversed procedure, all works.

Help other customers find the most helpful instructions.

Were these instructions helpful?

35 of 41 people found this instruction helpful

Parts Used:
  • Defrost Timer - 120V 60Hz
Level of Difficulty: Really Easy
Time to do repair: 15 - 30 mins
Tools: Nutdriver, Screw drivers
Customer: Wanda from Cabins, WV

Refrigerator was not cooling but the freezer worked fine.

My husband put on the defrost timer. At first I thought the part was not going to fix the problem. After about 5 hours my refrigerator was still warm. I went to work and when I got home that evening my refrigerator was cooling and down to 28 degrees. So if you replace this part wait at least 12-24 hours. Give it time to stablize. My husband says it has to go through its cycle. It works on a 24 hour timer. My refrigerator is working fine and this has saved me alot of money. My husband says, once you put on the timer you may have to use a flat screwdriver and turn the small dial clockwise one click to start it. He removed the kick grill and replaced the part. Dont forget to shut breaker off to replace this part. Turn power back on and start the timer. We are so happy that we now have a working refrigerator.

Help other customers find the most helpful instructions.

Were these instructions helpful?

25 of 33 people found this instruction helpful

Parts Used:
Level of Difficulty: Really Easy
Time to do repair: 30 - 60 mins
Tools: Nutdriver, Pliers, Screw drivers
Customer: Gary from Palm Coast, FL

Refrigerator section would slowly warm up.

Reading other after action write-ups I diagnosed the problem to be either the defrost timer or defrost thermostat so I decided to replace both. The timer was hard to find. Turns out it was inside the kickplate grill which made it hard to demount and remount while maneuvering the wire connector around. Just took a few minutes longer than expected. The thermostat was inside the freezer compartment requiring the refrig to be off and defrosted (heavy ice buildup on the coils confirmed diagnosis). Had to cut old thermostat wires and reattach new with crimp style wire nuts (provided with thermostat). Directions said to use silicone sealant in wire nuts - NOT provided. Need to attach new thermostat on top of coils with tie wrap (not provided). Overall reasonably easy with great results. Parts arrived very fast.

Help other customers find the most helpful instructions.

Were these instructions helpful?

23 of 35 people found this instruction helpful

Parts Used:
Level of Difficulty: Easy
Time to do repair: 30 - 60 mins
Tools: Nutdriver, Screw drivers
Customer: James from Glendale, CA

Refrigerator unable to cool below 50 degrees

The defrost timer was very easy to replace. Two screws and one electrical bracket and that was it. The defrost thermostat required the removal of the freezer shelves and rear panel. A philips for the panel screws and a slotted screw driver to wedge in-between the side and rear panel. The rear panelcame right out. The defrost thermostat is very accessible simply mounted to a metal bracket on the evaporator coil. My only problem was the new thermostat did not include instructions or a picture of a correct installation. The old thermostat did not seem it was installed correctly and it wasn't. It was simply hanging away from the evaporator coil, sort of out in space. Seeing the "V" shape on the new thermostat and metal mounting bracket configuration it was simple to see that it was suppose to fit snug against the evaporator coil. In addition to using the provided twist-on wire insolators I soldered the two electrical connections leading from the frig to the new thermostat. Reverse the above procedure and the job it finished. Now running better than new.

Help other customers find the most helpful instructions.

Were these instructions helpful?

14 of 16 people found this instruction helpful

Parts Used:
  • Defrost Timer - 120V 60Hz
Level of Difficulty: A Bit Difficult
Time to do repair: 15 - 30 mins
Tools: Screw drivers
Customer: Donald from worthington, OH

Refrigerator would not defrost

Look were timer was located, in my refigerator is next to the dial to ajust the temperature. used a screwdriver to get panel off. replaced timer then used a straight screwdriver to advance timer to turn on compessor . monitor temperature . checked out.

Help other customers find the most helpful instructions.

Were these instructions helpful?

1-5 of 11