CSK30DRBGAA Hotpoint Refrigerator - Instructions

Removed drawer cover, removed both drawers, unscrewed broken part, installed the new one, put drawers and cover back.

watched a 2 minute video on installing the connector. Then using the utlity blade cut out a 1/3" section of the tubing and installed the connector. DONE! Leak fixed

I followed the video instructions. They were clear and consise. I removed the trim ring and controls. Them removed the housing and flapper. I did notice a small burr in the plastic chute and foam insulation. I trimmed this off with a utility in hopes this burr caused the flapper to warp. This is the 2nd time the flapper has been replaced in 1.5 yrs. The repair was really easy thanks to the video.

removed 2 screws from broken slide, then I positioned the new slide in place and using original screws secured slide to wall of frig.

We ordered the part and it arrived two days later. Great quick service from Partselect.com.

remove 3 bucket screws. 1 bracket screw slide bucket back insert drive reverseb steps

I ordered the part and it was replaced. I always worry that I will get the wrong part or it will not fit. The on-line help with the model number gave me the right part, and this was an easy repair. Gusessing that I saved over $100 from needing to call a repair service!

It was exactly as shown in your instruction video

The parts purchased worked perfectly and your write-ups explained what the typical problems are with this water leak that was occurring with our GE refrigerator at the nylon water line for chilled water service. Your description highlighted exactly what the problem was and the parts that I needed to make the repairs. This saved me a plumbing service call. All I had to do was cut off the nylon hose beyond the cracked area, apply the water nylon tube union joining the two hose ends and tighten the coupling at the unit.

Thanks again,

Jim Macdonald

Went well. Changed the Ice Maker and then the Water Valve. All good and it is making ice.

Don't know why they broke in the first place but I suspect that the door was closed with the draw not fully closed. Very simple repair involving 4 Philips head screws (not included) Parts clearly marked left and right. Wise to leave broken ones in position for orientation reference before beginning. A digital photo works wonders as well.

couldn't be easy. the video that I watched help me get the right part and see the right way to repair thanks for that video

Watched à video provided at your website. Removed te cover then removed 4 screws holding the control panel' snapped out the old flap and inserted the new one.

I removed the front of the unit assembly and removed the entire auger unit and drive assembly. I married the old drive cup and new drive cup back to back using vise grip pliers, drilled 4 3mm holes, installed 4 phillips head stainless steel screws and, using an emory wheel, ground off the exposed screw ends. I then re-installed the drive assembly and auger unit. This increased the length of the drive cup allowing the drive to fit without any slippage. The entire cost was less than $18.00 including shipping and screws and took about 1 hour. It works great.

Watched the video that showed how to disassemble the ice maker. Then went right in and replaced the part and turned it on. It immediately started filling up the ice tray. I still have not been able to find out why it does not make as fast as the original ice maker. The tempeature for the freezer is set pretty cold.