CEM2940TQ1 Whirlpool Dryer - Instructions

unplug,disconect vent, remove the back, use the ohm meter test the thermal cut-off , test the heating element, test heat limit switch. ( that now comes as part of the cut off kit ) I tested the cycling thermostat but did not know the values so i ordered it as well. Did not need it after compairing the old to the new. every thing should show compleat circut except the cycling thermo's two center contact that should be around 8000 ohm. very easy repair and recieved the parts in two days. Watch the video.

replacer upper heat themo

Unplugged the power cord. Removed two screws on lint vent , used putty knife to release clips to raise top at front of unit. Disconnected the plug from front door switch. Laid dryer on its back. Removed two screws to remove front including the door. Vacuumed lint from inside unit. Installed belt temporarily using two pieces of masking tape to hold it in place while properly routing the belt. Gave the tub a full turn to insure alignment.. Reinstalled the front of unit with the two screws. Righted the unit and snapped down the top. Replaced the two lint vent screws. Plugged it back in and done! Piece of cake!

Once I watched a YouTube video showing me how to do the job I ordered the part from you. Am so impressed with your fast shipping and best prices via the Internet. Thank you SO much! The water level switch was easy to install, it ws getting the cover on the washer back on that was hard for me since I am 68 yrs old and have a bad knee. Its why it took me two hours to do what most people could do in 20 minutes.

I unplugged the dyer remove the back and took out the part and replaced it with the new one done !Thanks to your video I watch on the enternet.thank you so much

Followed procedures in Parts Select web site video

we received the two heating element wires in 3 days and connected the heating element with no problem works great.

I wasn't sure which part was the problem, but the PartSelect web site is very helpful suggesting likely parts for various problems. I ordered two parts from PartSelect - a Cycling Thermostat and a Thermal Cut-Off Kit. Each of the two parts had an installation video available on the PartSelect web site. I followed the video instructions for each part. Very easy to follow, no problems at all with installation, problem with dryer is now solved. I might add I was amazed how quickly the parts arrived after I ordered from PartSelect. Parts arrived 2nd day after placing order. I would not hesitate to use PartSelect for any future needs.