Models > CDE850 Maytag

CDE850 Maytag Range - Overview

Get Parts and Repair Help for CDE850

If you know the range repair part you need, you can browse the list of all parts on the CDE850, or you can search by name or part description. You can also find your part by where it is located on the CDE850 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for CDE850 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$2.58

Light Bulb - 40W

Sold individually.

$13.58

Grease Filter

The filter is made of metal and is intended for use with ranges and cooktops. As per the manufacturer, if this filter is 1/2" less wide than the original, it will still function the same.

$8.79

Surface Burner Receptacle Kit

This kit comes with one ceramic block, metal bracket, wires, and hi-temp wire nuts.

$2.70

Screw

This screw is sold individually.

$36.91

Door Hinge

This hinge is located on each side of the oven door.

$2.70

Screw

This screw is sold individually.

$24.23

Electric Surface Element - 6"

This surface burner with reinforced delta frame carries 1250W and 240V.

$59.24

Infinite Switch - 240V

This part is used for the 6" and 8" burners. Note: This part has been updated by the manufacturer. It may differ in appearance but will still function the same.

$48.30

Infinite Switch

This switch has a double-flat shaft that is 1" long. This switch is palnut-mounted and the 'off' position is at the top.

$2.70

Screw

Sold individually. Lock washers are used with screws when vibration from an appliance may cause the screw to loosen. Lock washers are also used in the electrical components of an appliance to ensure an electrical connection is not lost.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Replace Grease Filter

  • Customer: Gene from Washington C.H. OH
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 486 of 491 people found this instruction helpful
Just a couple of minutes to left off the cover grid, left out the old filter and drop in the new one. read more

Blower motor died and I needed to replace it

  • Customer: John from Berkley MI
  • Difficulty: A Bit Difficult
  • Time to Complete: 1- 2 hours
  • Tools Required: Nutdriver, Pliers, Screw drivers
  • 367 of 371 people found this instruction helpful
Most of the repair was obvious as I took the blower apart before ordering the parts. Unfortunately the new motor was significantly larger than the original motor so I had to um. Adjust the position of some of the other parts to fit it in. There was a sheet metal flange that was installed on the other side of the blower from the motor which was designed to f... read more

Stove top element not working due to bad receptacle.

  • Customer: Richard from Carthage NC
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers, Screw drivers
  • 113 of 123 people found this instruction helpful
Turned off the power at the breaker box, cut the wires approximately 5 inches from the bad receptacle and removed it after removing one screw. Stripped back the wires about 1/2 inch and attached the new wires with the ceramic wire nuts provided and secured the receptacle back in place with the new screw provided in the kit.
My sister's husband wanted to... read more