Below is a list of all parts for the Maytag Range CDE850 - Electric. To find the repair part you need, you can browse the list below or you can narrow your choices by searching for a part by name or description.
The filter is made of metal and is intended for use with ranges and cooktops. As per the manufacturer, if this filter is 1/2" less wide than the original, it will still function the same.
This kit comes with one ceramic block, metal bracket, wires, and hi-temp wire nuts.
This screw is sold individually.
This hinge is located on each side of the oven door.
This surface burner with reinforced delta frame carries 1250W and 240V.
Sold individually. Lock washers are used with screws when vibration from an appliance may cause the screw to loosen. Lock washers are also used in the electrical components of an appliance to ensure an electrical connection is not lost.
The top of this part is now black.
This part is used for the 6" and 8" burners.
Note: This part has been updated by the manufacturer. It may differ in appearance but will still function the same.
This switch has a double-flat shaft that is 1" long. This switch is palnut-mounted and the 'off' position is at the top.
This bake element has screw-in wire terminals. It's located on the bottom of the oven.
This cartridge assembly male contact spade is made of metal. These are sold individually, though each range uses four contact spades.
This part is used as a support for the grill element. Sold individually.
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2015 , Eldis Group Partnership. All rights reserved.