Models > CAV2005AWW > Instructions

CAV2005AWW Magic Chef Washer - Instructions

All installation instructions for CAV2005AWW parts

These instructions have been submitted by other PartSelect customers and can help guide you through the washer repair with useful information like difficulty of repair, length of repair, tools needed, and more.

All Instructions for the CAV2005AWW
316-319 of 319
Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

The lid hinges on our washer had broken off the pins and both needed to be replaced.

  • Customer: Suzanne from Greenfield MA
  • Difficulty: A Bit Difficult
  • Time to Complete: 1- 2 hours
  • Tools Required: Screw drivers
  • 0 of 0 people found this instruction helpful
The first thing we did was to lift the top of the washer off the main box by unscrewing the hinges at the back of the washer. We then were able to access the lid hinge screws located underneath the lid. We unscrewed and removed the old hinges from the washer, lifting the lid off the washer. Then we were able to unscrew and remove the old hinges from the lid itself. We then screwed on the new hinges and pins, and reattached the lid to the washer. Finally we put the top back on the main box of the washer and screwed the top back onto the main assembly, and voila! It works great and saved us $200 in repairs.

Shaking, bouncing, banging, during the spin cycle

  • Customer: Shad from Clearfield UT
  • Difficulty: Easy
  • Time to Complete: 1- 2 hours
  • Tools Required: Nutdriver, Pliers, Screw drivers, Socket set
  • 0 of 0 people found this instruction helpful
I followed the directions online, but they don't talk about two difficulties with this model. The first is removing the drive belt. This is CRUCIAL! Tilt the dryer backwards, and remove the belt from the pulleys. When putting it back on, when the repair is complete put it on the two smaller pulleys first, and then the large pulley. The other difficulty that is not addressed with this model is accessing the suspension springs. If you choose not to remove the entire housing, I would use a wooden block (2x4 works great) to act as a lever for the vicegrips. I may be weak, but I have a bruised forearm that would have been avoided if I had thought of the wooden block earlier.

Washer bangs while in the spin cycle

  • Customer: Eugene from Bergen NY
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Pliers, Screw drivers
  • 0 of 0 people found this instruction helpful
I removed the belt and pully form under the washer. Lefted the top cover, removed the hardware above the tub, took the front cover panel off to gain access to the tub. Used pliers to remove the springs. Lifted the tub up high enough to install the snubber ring. After putting tht washer back together and doing the first the load the washer stopped banging.

water leaking through valve with machine off.

  • Customer: Jon from NEW HOLSTEIN WI
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Pliers
  • 0 of 0 people found this instruction helpful
open top with putty knife. take screw out holding valve. unscrew hoses and reverse procedure. also replaced washers.
All Instructions for the CAV2005AWW
316-319 of 319