BSS25JFRFWW General Electric Refrigerator - Instructions

Turn off the cold water at the source. Remove metal plate from back of refrigerator at the top. Disconnect the two tubes that feed the water to the filter at the bottom of the back (behind the cardboard), noting which line takes the "blue" tube. On the inside of the refrigerator, pop off the top of the filter housing and set aside. Unscrew the two screws holding the filter assembly from the inside and pull the old assembly through.. Remove the plastic stopper (unless you are not using a filter) from the new assembly.Thread the new assembly tubes from the inside to the outside and reconnect screws and replace top of filter housing. Connect the new tubes to the water supply and to the refrigerator and tighten the nuts. Replace the metal plate and screws over the black insulated part at the top. Turn on the water and check for leaks. Replace the water filter..If a 68 year old grandmother can do it, so can you.

Turned power off at breaker. Took off front panel on the door. Unscrewed the panel where the electrical parts were plugged in. Then you could unscrew the old solenoid assembly and install the new one. Cleaned around the Ice shute since some mold was there. Put all back together. We watched the video from you tube about 5 times!!

Followed the Parts Select video step-by-step. It was exactly as the video described and took about 5 minutes (though I already had the cover off). Almost a week later and the refrigerator is running fine.

I replace defroste thermostat :i defrost al the ice