Models > ALW450QAW (PALW450QAW)

ALW450QAW (PALW450QAW) Amana Washer - Overview

Get Parts and Repair Help for ALW450QAW

If you know the washer repair part you need, you can browse the list of all parts on the ALW450QAW, or you can search by name or part description. You can also find your part by where it is located on the ALW450QAW by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your washer. We’ve also included any installation videos we have for ALW450QAW parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$4.46

Thrust Washer

$2.70

Retaining Ring

Sold individually.

$51.93

Pump

This pump is attached to the motor and helps expel water from the washing machine. It is activated after the spin speed is maintained for a specific period of time.

$3.76

Adjustable Levelling Leg

Sold Individually. This adjustable leveling leg comes with a stop nut.

$2.70

Screw

This screw is sold individually.

$2.70

Hose Clamp

$31.30

Spin Belt

This v-shaped spin belt helps transfer power from the motor to the transmission to help pump the water in and out of the washer. It also helps runs the spin cycle in the washer.

$18.77

Idler Pulley Wheel

This wheel has a center metallic bearing. A dryer's idler pulley wheel serves to help the belt to rotate the drum.

$2.03

Lid Hinge Mounting Screw

Sold individually.

$11.02

Idler Pulley Shaft

This shaft is made to fit the center of the idler pulley wheel of your dryer.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Belt wore out

  • Customer: Bruce from Medina OH
  • Difficulty: A Bit Difficult
  • Time to Complete: 1- 2 hours
  • Tools Required: Screw drivers, Socket set
  • 105 of 125 people found this instruction helpful
Had to remove pump-not easy. Nothing wrong with pump, but had to trash it to get it off the motor shaft, so I had to replace it, too.

Pop up top of cabinet and remove front panel. (I leaned unit back against a wall to facilitate internal access once panel was removed.)


Remove motor assy - 4 screws & connector.

Remove ... read more

DRIVE PUMP LEAKED

  • Customer: Stephen from Laveen AZ
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Pliers, Screw drivers, Socket set, Wrench set
  • 51 of 59 people found this instruction helpful
It took some trial and error but overall not a difficult project.

1. Take the front covers off.
2. Undo the pully spring to loosen belt
3. Remove belt off idler pulley wheel and free up belt from the large wheel.
4. Disconect the wiring harness and the hoses.
5. Undo the motor mounting bolts (4)
6. Take motor out of wash... read more

The spin belt failed due to overloading the washing machine.

  • Customer: Mark from Cheektowaga NY
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers, Socket set
  • 29 of 31 people found this instruction helpful
Unplugged the washing machine and turned off the water to the machine. Removed the two front covers; unhooked the two front springs; removed the (4) motor mounting bolts; unhooked the two hoses for the water pump; unhooked the wiring harness; removed the belt from the driven pulley; pulled the motor assembly out; removed the (3) screws to separate the water... read more