Models > ALG643RBW (PALG643RBW1) > Parts

ALG643RBW (PALG643RBW1) Amana Dryer - Parts

All parts for the Amana Dryer ALG643RBW

Below is a list of all parts for the Amana Dryer ALG643RBW - Residential. To find the repair part you need, you can browse the list below or you can narrow your choices by searching for a part by name or description.

All Parts for the ALG643RBW
1-14 of 91
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?

Multi-Rib Belt

At 93-3/8" in length, this flat dryer drum belt has 5 ridges and is 3/8" wide.


Drum Support Roller

This roller is for square-ported models and has a metallic bearing in its center. They are sold individually and most dryers use 2 rollers at the rear and it is recommended to replace both at the same time.


Drum Glide

This drum glide is sold individually. ***Please Note: these should be replaced in pairs.


Idler Pulley Wheel with Bearing

A dryer's idler pulley wheel serves to help the belt to rotate the drum.


Radiant Flame Sensor

This part senses the flame for heat allowing the gas valve to open.


Lint Filter

Note: This part no longer comes with the felt seal. This filter collects lint as it passes through the dryer vent.


Thrust Washer

This washer is 3/4 inches in diameter.


Door Catch Kit

This kit comes in two pieces: the catch and the clip.


Door Switch Kit

This part replaces older two terminal switches.


Cylinder Felt Seal

This part is located between the back of the drum and the rear dryer panel.


Single Drum Glide Felt Pad

This part is used on the front dryer drum glides.


Retaining Ring

Sold individually.


Cylinder Glide Bracket

These brackets support each side of the tub. Order quantity needed.


Roller Bracket and Shaft Assembly

This part is used to hold the drum in place while it is rotating on the support wheels.

All Parts for the ALG643RBW
1-14 of 91