AFD2535DEW Amana Refrigerator - Instructions

removed icemaker timer/controler replaced with new part.reinstaled it works perfectly

Direct part replacement. Very easy. Most importantly take your time. When ordering parts review drawings. Screws don't come with parts so save screws when taking it apart.

Followed video lnstructions which were very good. Have used your web site in the past and will continue to purchase products. Thanks.

The replacement of this dual water valve was extremely simple and required very basic tools. Total cost of repair was the valve cost only.

I removed the old icemaker, took it out to my shop & removed the wiring and etc. and put it back in place.

After a visit to your site, reading the different posts I was able to narrow my problem down to the dual water valve. The replacement part fit prefect. After I got the old part out I was able to blow air past the valve showing the valve did not shop water after filling the ice tray. When the supply of water didn't stop it froze up in the tube filling the ice ray.

I could have tested the old valve before I ordered the part by switching the output sides of the valve and water would have leaked to the drinking water supply inside the door to confirm what my problem was but I'm very happy with the repair and the company Thanks
Poppie

The door bin cracked. I ordered a new one and slid it into the old bins slots.

remove the wiring cover, pulled out the ice maker shelf, unpluged the wiring. Once out I removed the control module cover and remove 3 screws and pulled out the old control module. I pushed on the new control module and reattached the 3 screws, attached the module cover and plugged wiring in, slide back into the freezer track, installed wiring cover and screw- 15 minuits tops

Troubleshooted the problem using youtube ordered the part and fixed the valve with ease.

removed all the nuts holding the plate and the valve to the back of the refrigerator, removed the three 1/4in lines connected to the valve via compression fittings, replaced the valve, reconnected the waterlines, the plate and the bracket.
20 min job

sears wanted $450 to replace ice maker or $400 for refubished. I ordered a $60 motor/control unit from parts select. Remove ice maker, remove motor cover, three screws replace and ice within the hour.

Removed 4 screws, pulled unit out of slots, unpluged control wires plug and removed from fridg. Removed 3 screws that hold the motor module to unit. Then reversed procedure and had the batch of ice cubes one hour and fifteen minutes from the time I started replacement.

called a repair man

Bought this refrigerator secondhand from someone who was upgrading. They stored it on an unheated porch. When I connected the water line it started spraying everywhere. Removing the service panel showed the dual water valve had fractured and there was a big hole in the side. Replacement was fairly easy, but getting the existing hoses out of the sockets required a lot of prying. I have only attempted appliance repair a couple of times before.

removed front cover installed gearbox then attached lift arm plugged in frig turned on h2o and now i have plenty of ice ! ordered part on Saturday got part on monday in the mail and had ice by supper what a great place to shop and the service was great and parts made easy to find on the website. thank you very much! I will refer your business to all my friends.

Had to push the light switch to get lamp to light up.
Removed power from refrig. and removed old light switch
and replaced with the one I got from Partselect. Turned power back on and was done.