ADW662EAC Amana Dishwasher - Instructions
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Old basket worn, silverware falling through holes
-
Thomas from Washington, PA
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
Old silverware basket "collapsed"
-
Lawrence from Newport, ME
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
dishwasher making scraping noise when running
Took the dishwasher apart, then went the website and found an extra part. The discharge pump housing had broken into two parts. Order the patrs needed, they came in two days and put the dishwasher back together. It was easy with the help of the website and runs like almost new
Parts Used:
-
Doug from Columbia City, IN
-
Difficulty Level:Really Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Nutdriver, Screw drivers, Socket set
Was this instruction helpful to you?
Thank you for voting!
water was leaking from the right side bottom of the dishwasher
I pulled the old rubber gasket off put the new one on and then took the back end of a kitchen knife to push it in all around the door to create a solid seal
Parts Used:
-
John from Newport, KY
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
Dishracks were worn, pieces broke off
Replaced both upper and lower Dishracks, the Parts Select video shows how to replace the top rack but doesn't mention the lower one. Had a bit of a problem trying to figure out how to remove the spout on the bottom rack. Finally figured out, twist it counter clockwise to remove it and turn it clockwise to reinstall it onto the new lower rack.
Parts Used:
-
Richard from Lyndhurst, NJ
-
Difficulty Level:Easy
-
Total Repair Time:15 - 30 mins
Was this instruction helpful to you?
Thank you for voting!
The Old Silverware Basket Had Holes In It.
-
Janet from Greenwich, CT
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
rotting rack
very easily, old rack out, new rack in
Parts Used:
-
Mary from New Hartford, CT
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
silverware basket broken
-
Timothy from WHITE CLOUD, MI
-
Difficulty Level:Easy
-
Total Repair Time:Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
Snap retainer broke, dealer said he couldn't get it. Found your website, ordered the part and it came by FedEx in four days,
The spray arm was badly limed up, so I cleaned out the spray holes, inserted the retainer and snapped the arm in place. Works perfectly. Thanks!!
Parts Used:
-
Roger from Keota, IA
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
Not getting water, or enough water in the diswasher.
First I turned off the fuse and h2o, then replaced the intake valve. This was tricky b/c there is very little room underneath to maneuver the wrench. I had my son watch to see if h2o came out of the intake hose while I turned the h2o on and off from the main valve. Knowing I had h2o, I replaced the intake valve and turned on the machine. Still not working properly. Next, I ordered a new float and fill switch (the little computer chip looking thing). Replacing those was a snap. Remove a couple screws, replace the switch, screw back in place. The float was even easier, using pliers, I removed the nut from the float stem underneath, then simply pulled out the old float and dropped in the new. While keeping the door slightly ajar and holding the float down in place, I pushed the securing nut back into place. Again, I started the dishwasher, and again it did not fill. Frustrated, I removed the intake valve again. I used a wooden skewer to pull out some sediment that had been in the intake line (my son did not pick up on the irregular h2o flow during the initial test). Put the valve back in place again and viola, it works perfectly!
Parts Used:
-
Thomas from Abington, PA
-
Difficulty Level:A Bit Difficult
-
Total Repair Time:1- 2 hours
-
Tools:Nutdriver, Pliers, Wrench (Adjustable), Wrench set
Was this instruction helpful to you?
Thank you for voting!