ADB2500AWQ Amana Dishwasher - Instructions

I'm so happy I ordered these wheels, with them it's running
like new. Without the wheels it was making grinding sounds when it ran. You just push them onto the rack spokes and snap them in place. EASY!

i read how it was done on this web site

Turn off electric breaker to dishwasher. Remove all star head screws from inside rim of door pannel. Disconnet electric connetions (somewhat difficult-had to use pliers)from old handle then attach to new handle set in place. Srew door panel back on. Turn electricity back on.

Popped the wheels on just like the ones that were still there and it was good to roll. Nice!

installed rack stoppers. Didn't use tub wheels but fixed old (as best I could) didn't want to spent the money for rack adjuster at this time(wheels are part of rack adjuster assembly)

The 2 harness connectors to the switches would not come off. I had to finally remove the 2 new switches from the new handle/latch assm. and plug in the old ones with the harness bables still attached to them.This worked fine and resolved the door problem. Unfortunately, I am now forced to use the old original switches while the new switches remain in the shipping box. If the old switches go out, I have no idea how to remove the connectors so I can attach them to the new switches.

To open "stuck door", with right hand around upper right top edge of door and with left hand push directly inward on handle then pull out with right hand. It is a little tricky to do, but door will open. Turn off power to dishwasher. With the right size torx driver, remove the stainless steel screws around inside perimeter of door, left, right and top. Lift out inner door, which has a clip holding some wire in middle, so can;t lift all the way off. Lift it up enough to just "lift out" door handle/switch assembly. With power OFF, grab plug connectors and pull of old handle. Mine were very tight, and kind of rocked connector down and up while pulling and came right off. Plug wires into new unit, lay in place of unit removed just alighning to two pins. Lay inner door back in place, put screws back in, and you are done. VERY easy repair.

I probably could have nursed the dishwasher for years but with two young children it an impossiblity to achieve kitt gloves this repair required. My kids are just old enough to do dishes and the last thing I want is an accident with water running into the basement. Placing the order and receiving it almost too fast made the install simple, quick and my wife still hasn't noticed. I impressed myself with the quick turn-around but I repair cameras for a living so repairs are second hand.

Unscrewed door panel; replaced latch mechanism (old one was broken), including a bit of very simple wiring; screwed door panel back in place.
Dishwasher closes and runs fine now!

found the problem. took out old handle and latch assembly then replaced with the new one. straight forward, very simple.

unscrew door and replace door handle.
5 to 10 minute job

I watched your video on how to install the part. The actual job went as smoothly as shown. Saved a large repairman's fee. Thanx!

Replase door lach Thang you for the fast respons Peter Hansen

Opened the dorr, removed the inside panel = the most time consuming part - and then exchanged the handle assembly. Then replaced the panel. Snap!
The hardest part was determining the part that I needed - the right part that did not involve repairing the/an assembly. Luckily I got the right one and two un-needed parts.

Stuff happens.

removed top row of screws and two down each side. unplug electrical connectors. reverse operation. the amazing thing was i ordered the part on-line wed. , the day before thanksgiving, and it was here via fedex on friday, two days later. funny how some repair services tell you the parts are out a week to ten days!