AAV7000AJW Admiral Washer - Instructions

clicked on how to do it yourself on the part and video showed how to change it.

Tilted washer back and removed belt
Lifted front of top and propped up
Unscrewed two screws and removed front of washer
Disconnected two drain lines from tub
Disconnected 6 springs from tub
Removed tub
Popped off bottom plastic cap
Removed locking ring
Slid off gear from shaft
Unbolted screws from snubber support ring
replaced snubber
Put everything back together in reverse order

Worked like a champ!!!!!

I used a putty knife to depress the holding clips under the front of the lid, then raised the lid to access the screws . Using a phillips head screwdriver I removed the screws holding the hinges and removed the door/lid then after removing the screw holding the broken pin, removed and replaced it with the new pin. and reinstalled the two screws on the hinges to reinstall the lid, and snapped the top back down. The whole thing took me less than 10 minuites to accomplish.

I found the parts that needed replaced on the Parts Select web sight.I clicked on see install video icon for replacement of the parts that needed replaced and that made the repair real easy.

Replaced pump. Works great!

open top,remove back panel.then laid on the side and removed belt.remove hose from tub to pump.removed small hose for fill level.Hard part was to remove springs from tub.Then pull tub and transmission out of housing.Remove pulley from shaft.Lossen screws around snubber ring but do not remove them.Remove old snubber ring.clean surfaces with alcohol.install new snubber ring and assemble in reverse order.

Watched and followed the video

I found on-line that replacing the snubber ring may fix the problem and ordered the part. With the instructions also downloaded I started taking the washer apart. Without the instructions the task would have been more difficult and possibly disastrous as I might have taken the bolts out that tighten down the snubber ring. All went well with a little patience. The washer works good.

I replaced both the pin and the hinge. The old screws did not fit these parts nor did either of the parts fit the other part although they were almost identical. Screws should be included with the parts as these are supposed to be replacements. Do not try to order only a pin or a hinge without the other. Delivery was very quick.

I watched the video first. It was correct except for the tool was not a phillips screwdriver, but a torx drive. Rounding up the tools took the longest. Everything else was just like in the video.

watched youtube on how to change out the snubber ring. it was quite easy.

push the washer tub as far as you can and use a long screwdriver to take hinge off,do the same for other side. Lid will then be removed for access to hinge pin,remove hinge pin and reverse process. Very easy repair. Very fast delivery from PartSelect.

got the right part great service from partselect invited my bro in law 20 mins we where done.. no more violent shaking spin cycle thank you very much

1. Open washer lid.
2. Remove right hinge mounting screw by leaning agitator/tub assembly to the right.
Do the opposite for the left hinge mounting screw.
3. Remove and replace both hinge pins on the lid.
4. Install both hinges on the pins and install lid back on the washer.

found your web site and the helpful hints Thank you it works wonderful even washing heavy loads