7MWGD5700BC0 Whirlpool Dryer - Instructions

Watched the tutorial online. Took the back off- replaced the fuse. Put the back on . It was extremely easy !!

Removed power (un plugged), removed two screws on back top of cover allow top to lift up on installed holders., used screw driver at right front and left front to push in the locks on the plastic holders and lifted top and held up with board. Removed two screws holding the switch and disconnect it from the connector and installed the new switch, and connected to connector back up, removed board, lowered top aligned with the two alignment clips and pressed down to lock in place. Replaced the two screw removed from back, plugged back in the power and test the repair.

Not a handyman but this was an easy and cheap fix. Now the automatic settings are working and drying much faster. Unplug machine, front panel has 2 spring clips toward the edges that you stick a flat tool into and pull on the panel to open. Pull off the electrical connections from the old sensors by the right side of the lint screen. Needlenose pliers help with the one farther up there. Then just pull the old ones sensors out, stick the new ones in, reconnect the electrical and get ready to live the good life with dry clothes that don't smell musty.

Replace the switch in diagram #4.

Once I watched a YouTube video showing me how to do the job I ordered the part from you. Am so impressed with your fast shipping and best prices via the Internet. Thank you SO much! The water level switch was easy to install, it ws getting the cover on the washer back on that was hard for me since I am 68 yrs old and have a bad knee. Its why it took me two hours to do what most people could do in 20 minutes.

When the part came in. I unplugged the dryer. Pulled it away from the wall and took the back off. I pulled the wires off the old fuse and plugged them in the new fuse, then unscrewed the on nut that held the old fuse. Then slid the new one in and put the nut back on. Plugged the dryer in and it worked. So I unplugged the dryer and put the back on.

Removed the back panel, found the fuse and replaced it. Easiest thing I've ever done! I was expecting it not to be the problem, but I started with the "most common" issue via the website. Voila...it was the problem!

little more than vedio showed has a see thru door had to tke door off machine then was easy replacement and re install

Unlike your video, with this model, the thermal fuse is located near the front of the dryer, which I didn't find out until the back was already off.

Follow your instructions. Thank You

I watched the online video first, which made the removal and installation fast and easy.

I went onto the Part Select website, they have a problem solving section that told me the most likely part to replace first and a description of the machine and the location of the part. I purchased the part, I unplugged the electric cord first. I then opened up the front of the machine with a philips screw driver, changed the part with the philips scew driver, I put back the front of the machine and the machine worked. It doesn't get any better then that!

went online to whirlpool typed in my problem and. was directed me to Partselect which said it was thermal fuse and had picture where it was located and how to replace,easy as that.thank you PartSelect.Tim

Removed back panel to get to inside. Removed drum etc to replace drum rollers (ordered repair kit also), replaced the idler pulley etc, now like new. Repair successful!!!! Thank you!

replaced the two coils, which took about 10 minutes