7MMGD6630TQ0 Dryer - Instructions

Downloaded a schematic of the dryer controls. Watched a UTUBE video of how to remove the front panel of a Maytag Performa dryer. It was pretty easy. Consulted your website and found out that bad coils are typical of the symptoms 46% of the time. I have bought parts from you before and happy with results.

noticed that male half was in good working order, so I just snapped in the new female half; without any tools. easy repair!

easy as pie !

Followed troubleshooting steps. Checked thermal fuse (shorted)- OK. Checked igniter (about 70 ohms) - OK. checked flame sensor - (open) BAD (should read shorted). This part is normally shorted then opens when the igniter gets hot causing it to open and thus turns on the gas flow. An open flame sensor does not permit the igniter to turn on.

the video was very helpful

The part was delivered when promised. Part was a perfect fit. I was very pleased with the entire process.

Watched how-to video provided on PartSelect website. Most time was spent cleaning out the cabinet of lint and other debris. I found over 5 bucks in loose change! I Found pulling the belt over the motor pulley to be the trickiest. Note: my dryer will be 30 years old come this September. I wonder how many more years I'll get out of it!

I order the part from you and you had a detail video on how to replace the door switch, and it was on the money, THANK YOU

video describing repair very helpful. just folling it made the repair easy

Purchased a new lint filter. Delivery and installation were no problems. The easiest repair that I've ever done.

I needed to replace our drum support rollers - one was completely worn out and wobbling (the buffalo herd noise) the other wasn't too bad, but for an older dryer(15+ years) I figured it was time to replace both wheels. I ordered the maintenance kit that also included the Idler Pulley and drum belt. I spent most of my time with the vacuum since there was a lot of dust accumulated inside the dryer. (I recoverd $1.83 in coins!) The instructions that came with the kit were very helpful for this repair. Plus, there were some online videos that heled as well. Once I had everything apart I noticed the plastic bearing ring on the drum's front was nearly worn out so I quickly ordered this from PartSelect and it arrived quicly in two days - this took only 10 minutes to replace.

Once diagnosed, repair was fairly simple. Shut off gas and electric first of course... had to remove the front panel to access valve assembly. removed 3 screws that hold valve assy to floor as well as 1 screw that attaches valve exhaust to the burner assy. reposition new valve assy and reverse the process. was done in about 20 minutes. The wife is once again a happy woman!!

We usedthe instructions that PartsSelect offered. Unscrewed the top in the back of the dryer lifted it up and replaced the part. A Lot cheaper than calling a repairman...

Can't stop laughing about the mistake I almost made, before I even looked on internet I called Sears and scheduled a repair appointment, $80.00 just to have someone come out and tell me what my problem was not to repair it but to tell me whats wrong. And I told them the belt had broken I heard it when it snapped. Long story short version I found your website and entered appliance information, found part for $15.00 but also found on-site video clearly making the needed repair. Clear step by step instructions taking only 8 minutes looked very easy so I took a chance ordered the part two days later part arrived so I went into basement armed with laptop and tools. MAN it was easy.... too easy ....worked out fine video was spot on. Thanks you guys are a great company

Belt was worn, rollers were sticking, idler worn out. Ordered a kit to care for these issues, as usual the reapirs took almost no time. Dryer became a bit quieter for a first load, second load the motor siezed. I priced rebuilding most of the machine and determined replacement was due.