6ALBR6245JQ2 Whirlpool Washer - Instructions

I watched the short video that was in the email with my order confirmation and all turned out well.

I just followed the video step by step. It was exactly the same. Very quick, very easy repair.

There are youtube vids on how to get the thing open. I just wish I'd known the following: 1.remove agitator BEFORE opening the unit up and leaning it back (much easier to work inside the tube with it upright). 2. be aware that a free-floating part known as the skate plate can dislodge while the unit is on it's side/back. It is a generally triangular piece of flat-ish metal between the base of the tub and the top of the drive-train chassis. If it doesn't line up properly after you replace the parts you're going to get a noisy, clanking spin cycle the next time you run the thing (as I discovered).

I pulled out the old cap with my hands and jammed the new thingy into place. The lady of house did the repair. Easy

The prooblem started with the hole in the bottom frame, for tub spring wore through, spring fell off, then a spring retainer worn broke in 2 releasing 1 suspention spring. All springs were about to fail, metal very thin at at the contact points. Drilled a new hole for the new suspension spring, replace all 3 brackets, worn also, springs, and retainers with a small dab of grease at the contact points. The new springs mad the tub more stable than before the failure, and silent when spinning or washing. Be careful to get the springs in the right direction, then the spring comes over the outside the brackets and retainers, other way they rub in spots. On this machine one was backwards from the factory 18 years ago, surely that accounts for more stable running.

I would like to preface this comment with the fact that as a 72 year old female retiree the need to conserve $$ was paramount. The instructions provided with the purchase of the part were clear and concise. First, I removed the cap on top of the agitator, (some machines have a fabric softener dispenser) then removed the small screen exposing the Nut that attaches and tightens the agitator to the machine. After loosening the nut, one hearty tug removed the entire agitator shaft allowing me access to the agitator cogs. After removing the worn cogs and replacing them with the new I then put all components together, tightened with the socket wrench and now have perfectly functioning agitator. Thank you!!

Age and condition of the washer were unknown. I had no agitator grease available. I went for just the replacement of the Agitator Directional Cogs. I reviewed the video for replacing the whole kit. Removed fabric softener dispenser and the seal below. The seal needed to be cleaned. Removed the 7/16" bolt with a socket and extra long extension. Removed the agitator. Pulled off upper agitator. The part that holds the cogs is in about the center of the upper agitator. It also needed to be cleaned. One original cog was broken the other were past needing to be replaced. Replaced the cogs and the retainer. There was some effort with getting the upper agitator down far enough to re-install the bolt. That was just a slight alignment issue. The other parts were put back in place.

I did repair myself with your instructions. it was very easy to do for my age. 84.

Everything we needed was include in the Agitator repair kit to fix the problem of my agitator not turning. Easy to replace the old parts with the new. Machine works beautifully now. Happy that I only had to pay for repair kit instead of buying a whole new machine or having repair man to come and fix it. Would recommend everyone to check here first for problems with machines. Love the video that shows step by step instructions on how to install parts. Will use this website again when needed.

Found excellent video on website that showed all needed operations very clearly. Followed printed directions.