4KSRS22QDA00 KitchenAid Refrigerator - Instructions

I followed instructions in the video you provided. No problem at all. Took less than an hour.

Just looked at your video twice and then did it with no problems. Thanks

fisrt i watched your video loosened two screws removed one removed icemaker installed new one tightened screws had ice in 2 hours i never shut the water off no need

the online video on how to change out the part saved me tons of time and do it right.....keep those videos coming, also right part too and easy to find on your site

I tried to just replace the cover rather than the whole unit but it was impossible - the cover would not go/stay on. I tried to remove the old unit completely but it would not unplug it was practically fused to the back of the fridge and the liner was cracking. I ended up breaking the cover and jerry rigging it over the bulb to prevent items in the fridge from being able to touch. Bad solution.

I was able to verify that the water inlet valve was ok based on shorting the test points as described in the online ice maker troubleshooting guide. I then ordered the replacement ice maker and received it within 3 days. The repairs went very smooth, remove 3 screws, unplug connector, transfer shutoff wire to new unit, connect power, replace 3 screws. Done. Ice bucket was full within 24 hours.

repair went well. Ice maker still not making ice. UGH

I watched the parts select YouTube video. The repair was a piece of cake. We now have ice again. The part was correct and arrived in just 48 hours. Perfect in every way.

I followed the instructions that came with the part. Less than five minutes it was good as new.

I watched the video on you tube and followed his instructions. It was very easy, it took about 20 minutes from start to finish.

Unplug refrigerator and turn water supple off. Remove three mounting mounting screws and unplug the old ice maker.(there is a latch on the plug to release it) Remove shutoff arm from old unit or if ordered seperatly with the ice maker, install shutoff arm on the new unit. Plug the new unit in (latch will snap into place when plug is properly seated.) Install the bottom screw (leave screws loose until all are started in the orginal holes). Tighten screws and you are done. Turn the water on and plug refrigerator in. After about an hour or two the ice maker will be cold enough to start making ice. In about five hours or so you will see the first ice cubes!!!!

part better than original just unscrewed and removed original. new one fit just right.

I watched the video and made sure my replacement ice maker matched the original. On my particular icemaker/refigerator combination, the electrical connection was slightly different than what was shown in the video, but the process for removal and replacement was very similar. I believe if more videos were available that were of the quality of the one on this website, there would be more people attempting to replace parts. I believe I saved over $200 by doing it myself. Kudos to the website and video people.

Turn off power to the frig. Remove the shelves and back brackets from the freezer, then with a 1/4" nut driver remove the nuts holding the rear metal panel in place. Once removed the defrost thermostat is right in front of you. You will have to clip the wires from the old t-stat because they are in a harness. Once clipped, strip the wires back, wire in the new t-stat, add wire nuts and put it all back together. Very easy job to do, works great. Thanks Parts Select, Mike.

Removed front panel by inserting stiff putty knife at bottom and gently prying snaps loose. removed two screws holding electrical board. had assitant hold both out to one side without removing their connections or wires. Cut off old water line about three inches behind broken nozzle. Cut head off a small screw and used threads to connect cutoff old hose to new hose. Pulled both through door and out bottom until new hose appeared. Very easy.