49-2847-23-01 Tappan Dryer - Instructions

I got my order THE DAY AFTER I ORDERED IT!!!! I didn't expect that. If you can use a screwdriver you can install it. I would use this company again for anything I needed like this. Great service!!!!!

I removed two phillips head screws, lifted out the old screen and frame, dropped the new frame and screen in place and replaced the two screws. Total time to repair was less than 90 seconds.

Took the coils off and put the new one on thats all

The other door latch broke and fell out. I simply pushed the New Door Latch in the hole, and it snapped into place.

Had the macnine apart before ordering the Bearing Assembly. Reading other comments convinced me to order the Bearing Assembly. Parts were shipped very quickly after ordering and following the instructions on the web site things went back together easily.

Replaced rear bearing on back of dryer. Repair cost $20.00 an a little time. Much better then buying a new dryer. It was easy to repair the video instructions were great. I would do it again it needed.

Found instructions on "UTube"some of the screws were in a different position but you can see them. While you have the dryer apart it's a great time to clean it and also as long as you've gone this far replace the belt,it's probably time.

The new latch easily snapped it into place.

took front panel off, removed access panel in rear to disconnect the belt from motor. removed top panel (this is a stack unit) take plastic rivets loose from lint trap, remove lint trap tube, pull drum out after slightly pulling up to dislodge drum from bearing cradle, Remove bracket and bearing from back of unit, clean parts of old grease (be carefull not to loose small ball bearing on back) Reassemble parts using moderate amount of new grease, put parts back together in reverse order.

This is a front load dryer. First unbolt top cover of dryer. Then unbolt screws and connections to control panel. Next unbolt all screws holding dryer door and front bottom panel. Next take belt off of drum and slide out drum from the front. From inside of drum remove 3 screws and remove bearing then put new bearing on and bolt up the same way you take old one off. Using an 8mm socket or wrench remove plastic bearing cage located at rear of dryer. When unbolting there is a retaining clip and small steel ball to be removed from back of dryer. Replace this the same way you take it off. He sure to grease the bearing cage then replace everything back from putting the drum in first to your last step bolting on top cover of dryer. Hope this helps anyone doing this repair.

Hired a professional!

I have used this company twice now and both times have been a good experience. Would highly recommend!

Screw driver two screws and 25 sec.

Everything I needed to know was already on your website. Prying off the top of the dryer (with a big screwdriver under the front of the top) was the hardest thing, since I was afraid I would break something. Only then can the front be removed (taking out just 2 phillips screws). The rest is easy.

I just changed the lint trap. the amazing thing was that I ordered the part one afternoon to be delivered USPS and figured I wouldn't see it for weeks. BAM! the next day I got this part in the mail. it was kinda weird. Are you guys living in my basement?