All Installation Instructions for Magic Chef Range 41DN-3GKLW

Plastic clips had broken, causing bottom skirt piece to fall off.

After attempting to order this part from Whirlpool twice and twice receiving the wrong thing, found correct part on PartSelect in about one minute. Shipment came fast and the repair was very simple, under five minutes. You just pop the pieces in place and snap the piece back onto the oven.

Parts Used:

Single Door Strike

William from Greensboro, NC
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

28 of 29 people found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

Rubber gasket failed due to age

I learned that I could clean the window in the oven door. In taking it apart I saw that the gasket had fallen into the oven door. I found the part online, it arrived in three days. I removed the metal part of the door, removed what was left of the old gasket and put in the new one. Put the metal part of the door back on, and it was as good as new.

Parts Used:

Window Gasket

Mary from Woodland, WA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

14 of 18 people found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

Purchased home but stove had no broiler pan.

Purchased 2 piece broiler pan from this site

Parts Used:

2 Piece Broiler Pan

Raymond from BLOOMINGTON, MN
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins

14 of 20 people found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

Heat was escaping from my oven and really heating up my house

The heat sealing strips are elastic type material with hooks on each end. I simply removed the old strips and hooked the new ones in place.
It was easier than I ever dreamed possible!
And my kitchen is now nice and cool.
Pat Morrison
Sanger TX

Parts Used:

Oven Door Seal

Patricia from Sanger, TX
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

5 of 6 people found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

light bulb in water ice freezer door went bad

I didn't. Don't know how to get to light bulb to change it for this specific model

Parts Used:

Light Bulb - 40W

Carl from RIVERSIDE, CA
Difficulty Level:
Very Difficult
Total Repair Time:
More than 2 hours
Tools:
Screw drivers

7 of 13 people found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

Lower panal would not stay in place because plastic fastners were gone.

I inserted the door strikes in the proper position and then snapped the panel in place.

Parts Used:

Single Door Strike

siri from remsenburg, NY
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

4 of 5 people found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

Replacing the bulb in the freezer side

Removed the ice brucket,
Removed the light shield by releasing one screw using a nutdriver.
Replacing the bulb and reinstalled the light shield.

Your web site is one of the best and most helpfull service sites I ever used. Just wish that in the future you will ship parts overseas.

Parts Used:

Light Bulb - 40W

Yafa (and David) from Bothell, WA
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins
Tools:
Nutdriver

5 of 10 people found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

needed to replace a side oven door seal

The trickiest part was making sure that the correct part was ordered. The first attempt was a failure. The seal was too long and the clips were too big.
After finding the correct part it was a breeze.

Parts Used:

Oven Door Seal

Robert from Lebanon, NH
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins

3 of 5 people found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

Simply remove and install new parts

Overall, it was painless and easy with zero problems

Parts Used:

GRATE BURNER

Jacob from LITTLE CANADA, MN
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins

1 person found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

35 year old range. grates too dirty to clean. Parts Select had exact replacement grates. Perfect fit.

Easy, removed from box, put in place on range. Happy customer. Good company to find exact replacement parts.

Parts Used:

GRATE BURNER

FRANCES from AFFTON, MO
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins

1 person found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

Thermostat bulb was hanging loose

Removed what was left of the original clips. Pressed in the new clips and snapped in the themostat blub

Parts Used:

Thermostat Clip

Willi from Old Saybrook, CT
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Pliers

2 of 5 people found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

burned oven bulb

The hardest part was taking out original light bulb because screws on shield where hard to unscrew after all this years . The old bulb vent out leaving neck in socket. It took narrow electrical pliers to get neck out .The generic appliance bulb did not fit and had aluminum neck ,not recommended for brass sockets in ovens.Putting new light bulb in was not the problem.

Parts Used:

Light Bulb - 40W