3RAED3005TQ0 Admiral Dryer - Instructions

It was all put together... I just switched them!

Determine the problem, Lift top of machine, disconnect wires to door sw. Bypass the sw, and short the circuit, with piece of wire, push start, the machine worked..problem solved. Replace sw by removing 2screws ,attach wire connectors. Done job.

I watched you repair video and did as instructed. I used putty knife to pry open clips holding top down. Then a philips head screw driver to unscrew old switch and insrall new switch. Also putty knife helped to pry old wire harness apart.

this belt is too thin for the capacity of this dryer.I had only removed the front panel,replaced the belt and immediately the dryer start.

watched the video on part select.com was a very easy job whenever you had someone showing you what needed to be done,thanks for the help and great customer service.

Just follow the video by Parts Select., The repair is really easy.

Power off by removing plug from wall outlet. Remove two Phillips screws under lint screen filter door. (careful you don't drop them down the filter housing) Pry upper lid loose at both front corners and elevate and retain the lid vertically. Separate old 3 wire switch connector splice halves at upper right housing corner. Remove two Phillips screws at upper right corner of outer front doorway which hold switch. Install new switch with those two screws. Re-connect the connector splice halves; they are keyed for one direction. Close down lid. Plug in power cord.

Per video demonstration offered in web. Very simple. Thanks for your help.

Video showed 3 ways to remove the top section to access the switch. None of which worked on my unit. Instead there were 4 screws on the rear section of the control panel that had to be removed and then lift it past the top of unit to slide forward to remove top to access the switch after that all was the same as video.

Removed power (un plugged), removed two screws on back top of cover allow top to lift up on installed holders., used screw driver at right front and left front to push in the locks on the plastic holders and lifted top and held up with board. Removed two screws holding the switch and disconnect it from the connector and installed the new switch, and connected to connector back up, removed board, lowered top aligned with the two alignment clips and pressed down to lock in place. Replaced the two screw removed from back, plugged back in the power and test the repair.

Once I watched a YouTube video showing me how to do the job I ordered the part from you. Am so impressed with your fast shipping and best prices via the Internet. Thank you SO much! The water level switch was easy to install, it ws getting the cover on the washer back on that was hard for me since I am 68 yrs old and have a bad knee. Its why it took me two hours to do what most people could do in 20 minutes.

Follow your instructions. Thank You

Removed back panel to get to inside. Removed drum etc to replace drum rollers (ordered repair kit also), replaced the idler pulley etc, now like new. Repair successful!!!! Thank you!

I watched the PartSelect video once before the part arrived. Had the part replaced in under 15 minutes. Very quick and easy.

I followed the directions on your site. I pulled out the filter on the top of the machine. Then removed the two screws where the filter is located, I am not sure I would have found those screws had it not been for your directions. I then pulled up on the top of the machine by grabbing the sides near the front of the top, it came right up. I then raised it enough to place a broom handle to hold the top up so I could reach the switch. I removed the two screws holding the switch and then pulled the connector apart. I then replaced the switch with the two screws and plugged the connector back together. Removed the broom handle and closed the top and replaced the two screws I removed by the filter. Replaced the filter and started the machine running and opened the door and it turned off and the light came on. It took me about twenty minutes.