Models > 3DWTW3000FW0 > Instructions

3DWTW3000FW0 Whirlpool Washer - Instructions

All Instructions for the 3DWTW3000FW0
46 - 48 of 48
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Top part of agitator would not work
Removed the Softner cup, then removed the water cover from inside the agitator, removed the bolt that holds the agitator down to the stem, removed the old part and reinstalled the new parts looking at the parts list provided.
Parts Used:
Agitator Kit
  • Charles from Middleburg, FL
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Socket set
Was this instruction helpful to you?
Thank you for voting!
The seal was broken on the agitator cap barrier
Removed the fabric softner at the top of the agitator (needed a screw driver to pry it loose) and reached in to grab the barrier with my hand and pulled it out, very simple to do.When I put the new one in I put some liquid soap on the gasket and it snapped right into place.Very easy to do, all is well now, thanks Part Select.
Parts Used:
Agitator Cap Barrier with Seal
  • Ralph from New Milford, NJ
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Screw drivers
Was this instruction helpful to you?
Thank you for voting!
Lots of gunk between fabric softener dispenser and where it attaches to the agitator
Rubber O ring around the Inner Cap was rotted and busted through. Replaced with new Inner Cap Seal. Easy as pie!
Parts Used:
Seal, Inner Cap
  • Gregory from Sandy Springs, GA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the 3DWTW3000FW0
46 - 48 of 48
Back to Top