2VED21ZKFN00 Whirlpool Refrigerator - Instructions

First I had to tilt the refrigerator on wood on the supports under the refrigerator, the wheels were easy to get to then I unscrewed the old ones and replaced them with the new better wheels. The old ones where plastic.

i blocked up door took brakets off replaced plastic cams put back together door works like new one

Removed the door, installed the lower cam & re-installed the door. Diagram & parts list correct. An easy repair.

Removed top cover, then removed top hindge pin plate, then removed the door. Replaced the Lower Door Closing Cam, Reinstalled door and hindge pin plate and cover.

pulled all shelves from refrigerator door. unscrew the top plate and lift door out of bottom. pulled old cams off the door and the lower bracket and installed the new cams. put door back on and screwed the top bracket back on. installed the door shelves back in the door. never took the food off the door shelves. easy, easy, easy.

This was a really simple repair, but Parts Select made it super simple. The website was really easy to use and the parts arrived very quickly. I'm glad I found this website! Thank you!

Part arrived overnight. The How-To video at PartSelect showed the procedure exactly. It took about 30 minutes.

Took off the top cap, undid the 3 screws holding the top door bracket on, took off the door, repshove the lower door closing cam pieces, and then put the door back on...piece of cake, dude.

Removed door,took out old part@replaced with new

It was actually very easy since the parts were already missing. It required no tools just some elbow grease. The end caps snap on to the retainer bar very easily. Once they were put together it was just a matter of snapping them in to place on the refrigerator door. You do need to line them up and I found it easier to snap them in on the bottom first and then snap in on the top next. Very simple and for the money I spent on parts I have a used (garage) refrigerator in good working condition for right around $200.00. I would definitely order from PartSelect again.

Removed the broken trim by hand. Order and fitted the new product. Installed the same way the old one came out.
Level of diffficulty, 5 being the hardest, I rate this a ONE.

Removed door, removed both upper and lower cam and replaced, applied small amount of vasoline and replaced the door. The entire repair took less than 5 minutes. Door works great. When replacing the cam you need to replace both the upper and lower cam. When you order the parts, the upper cam is on the door schematic and the lower cam is on the refrigerator body schematic. I originally only ordered the upper cam.

All I did was removed the stickers and place it in the frame - no tools required. It fit perfectly and is since it is clear (the original one has a grid pattern in it) I can easily see everything in the drawer below. I will be more careful in cleaning this one - apparently the temperature difference from cool to warm caused it to break, so I will just wipe this one down rather than submerging it in water.

removed door and replaced the two parts

All you need is nut driver. Top hinge has 3 screws. Once you remove the screws, lift door. It is light. I place door of my sofa. I removed screws and pried the cam insert with a spatula. You can also you flat screwdriver. I also replace the other piece located at bottom of refrigerator. Now place door back onto metal rest. May need someone near floor to guide you. Once on the rest, close door and replace top screws. Forgot to mention that I emptied door shelves before removing door.