2DLSQ8000JQ5 Whirlpool Washer - Instructions

I watched the video and it was quite easy to understand and it went very smoothly.

removed the two screws from the back of the dial bar on the top of the washer. removed original unit, and install the new unit.

disconnect the electrical and tilt the machine far enough to reach under and remove hose clamp.Remove old hose and replace with new one.

The old one was easy to take off once I figured out how to get the back of the washer off. Then, the new one was on in just a few minutes and the washer is washing fine.

I was expecting to spend $100 or more if not having to go buy a new washer. I found your site and I was like "wow" then I found the Video of the intsual. It could not be any more simple. Entire job took 5 min. And under $4 for parts. All I can say is outstanding and thank you

Unplugged the machine and turned off the water, (hot and cold), removed hoses from valve. Removed two screws holding console to top. Removed screws in rear holding rear panel to cabinet. Pulled cabinet out of the way. Disconnected electrical leads from valve solenoids. Used nut driver to remove screws removed valve and mounting plate from the back of machine. Pliers compressed snap ring holding fill tube to valve. I reversed the procedure to reassemble. Most difficult part was getting the cabinet back in it's place. Washer fills like it is brand new!

DIAGNOSIS 1) Popped off the agitator cap. 2) Used a 1/2" socket extension driver to back out the plastic retention nut 3) removed the agitator and poured all the little plastic pieces into my hand 4) googled up the agitator assembly by model number, led me to Part select website 5) identified the plastic pieces as "dog ears" 6) ordered new dog ears for just under $4 REPAIR 1) waited 3 days and got dog ears in the mail 2) had a beer and opened the mail 3) inserted the dog ears into agitator assembly according to the picture on Part Select web site 4) had another beer 5) installed the agitator back into the washer, tightened the retention nut 5) admired my handiwork with another beer 6) washed a load of clothes DIAGNOSIS TIME - about 15 minutes REPAIR TIME - about 4 minutes plus 10 more to drink the beers

New hose arrived in 2 days in excellent condition. Repair was fairly easy and fit perfectly. Did notice, however, that new hose was upgraded with a thicker part and a clamp that fit much better. Old hose cracked from repeated shaking where clamp was not tight enough and the hose at this clamp was too thin compared to the new hose. We felt it seemed obvious that the manufacturer must have had many complaints about this original hose. But thank you for your fast delivery and excellent new part.

I gave the parts to my wife. Then I took them back and fixed the washer .

The repair went very quick and easy. What made this repair so quick and easy is because of the very prompt and quick shipping of the replacement part from this company. This was my first experience with this company and will always use in the future. I ordered the part one day and the very next day I received the part. Great job to this company!!!!!

I took out the old inlet valve and put the new one in. It was easy

Removed the top part of the electronic panel. Removed the top lid. Removed the old tub springs and replaced them with new ones. Works great and for only $20.00. It beats buying a new washer. Thanks!

Pulled off the old dispenser and popped on the new one. As easy as that. No tools needed. By the way. The service at Partselect was unbelievable. Had the part in about four days. Thanks Partselect.

used socket wrench with an 8in extension to remove agitayor bolt that was under cap on top part of agitator. was back together in about 15 min.correct parts were shipped in record time.

Removed and took apart agitator and replaced directional cogs.