10651554101 Kenmore Refrigerator - Instructions

Top left mounted Icemaker facing front. Disconnect power to fridge. Using 1/4" nut driver remove single silver nut under right rear side. It holds a plastic cover over the electrical connection, unhook the cover and remove it. Release clips under front lip under both sides and entire icemaker will slip and twist out. Remove electrical connection to ice tray. Place assembly on bench and remove 3- 1/4 hex screws from under side to release bottom tray. Snap cover off motor and remove. Carefully align pin and arm on control assembly to ice tray and-re assemble. May take 30 min to dispense. Discard till clear.

Watched the video it was right on, no problem.

installed o/l unit which was #1 on instruction sheet ,very easy, pluged side by side refrigerator freezer in ac outlet, checked amps on compressor, and a very happy ending! THANKS!

I checked to see if the compressor was running and it was not. I check the defrost fan and the compressor fan and they both were running. All lights were on inside the refrigerator. I then checked the compressor connection and using the multimeter I check for voltage on the two wires going to the compressor and I had 120VAC on the terminals. I then removed the start relay off the compressor as well as the overload relay. I then check the OHMS reading on the compressor terminals and I had good readings. I shook the relay and it was rattling. At this point I search on the internet for the start relay and ordered the parts. Received the part in two working days. Replaced the components and bingo everything started working. It took me more time to troubleshoot the problem than it took to replace the parts. Vernon

I shut the unit off for about ten hours and when I turned it back on and set the temperatures for the freezer and refrigerator it has been working great.I will keep the part in case it happens again.

Watched video