10650567992 Kenmore Refrigerator - Instructions

took out the old one and replaced with new. PERFECT FIT.

repair went well. Ice maker still not making ice. UGH

First I used some glue to stop the crack from spreading, and that worked for a while, but then I deceided to get a new replacement part. What I got was better than the original one as it had a white protective piece over the end of the drawer and I believe that will give more protection to the drawer. My kids did not always close the drawer all the ways and that is how the crack started. So now the refrigerator looks like new again.

Watch the video was very helpful. I'm just a women and I did it all by myself. Thanks for the help of the video.

After figuring it out, Some changes had to be made, but everything went smoothly

Took the cover off the relay parts with pliers removed the relay replaced bad part with the new parts and put the new cover back on plug the refrigerator in and it started to cool off and it is running great so far . A 46 dollar parts and it saved me a lot of money and it only took 15 min. Thank you

I got the new part and unplugged the refrigerator. I removed the wire auto shut-off. I removed the old motor assy. I checked to see if the motor quit running at the same locations as the new one before removing the entire ice maker. Lucky it did, so I installed the new motor assy without having to remove the ice maker. It took 10 minutes at the most.

Set out an area large enough to lay the door down once I took it off the refrigerator. Took off the top screws and hinge. Had my 12 year old so help me with the door and hand me all the tools so I could quickly change out the parts and not leave the Refrigerator open for too long. I think from the moment we took the door off to the moment it was back on was probably about 5-6 minutes tops. That is how easy this was. All the parts fit and thank you to PartSelect and it great website that advised me of the second part that went with the first if not I would never have known. Thanks again!!

Verified that the sensors were working. After removing the Ice maker assembly from the sliding track, I found that the indexed drive wheel on the motor had broken off from the shaft mounting. I ordered the Icemaker control and motor assembly from Partselect and swapped out the bad part. It only has three screws to remove and replace so it's fast and easy to fix.

just removed tho old one and inserted the new one job complete.

Push it in to place very easy.

REMOVED three bolts holding the housing had a little trouble getting the housing out far enough to get the water lines back on that is when i had to use the needle nose.30 min at the most Thank You

Pull the ice maker out using a nutdriver Pull the use a srew driver to remove the srews did the same to replace it put it back in had ice in 20 min

Removed old crisper tray and inserted new crisper.jod done

After googling for a parts supplier, PartSelect.com came up. The site was well done and had the Parts List conveniently available. I watched the associated video which was the highest quality "how-to" repair video I have seen. As it turns out, though, the icemaker does not have to be removed from the freezer unit. I removed the icemaker's shutoff lever, removed 3 screws, pulled the motor assy off, slid the new motor assy in place and re-installed 3 screws. Reinstalled the shutoff lever per the video and JOB DONE.