10650456901 Kenmore Refrigerator - Instructions

removed old part and screw from bottom of ice bin, installed new part with screw & back in business.

I pried the old one out with a screw driver and pushed the new one in. I expected instructions in the box it came in but there were none.

I removed the ice bin to clean out the ice when I noticed the broken part under the bin. I went to my local parts supplier and was told I had to replace the entire bin and assembly for about $185. I found your web site and recieved the part the next morning for $17 including shipping. It was repaired in 5 minutes. Thank you Parts Select.

I watched the video on your web site and did exactly what the video showed. I could not a get an appliance parts shop to tell me how to test the sensor, so I went on your site. It not only showed me how to change the sensor,it showed me how to test the sensor in my refrigerator. I have changed ice makers before, but never the sensor. Your site saved me $75 dollar service call and saved me $35 dollars on the part. Thank you very much!!!!

Took off the top cap, undid the 3 screws holding the top door bracket on, took off the door, repshove the lower door closing cam pieces, and then put the door back on...piece of cake, dude.

My ice maker would not produce ice. I removed motor module which involved removing ice maker from freezer, removing motor module cover and 3 screws. I found short (burnt place) in copper of existing module. Ordered new motor module, replaced, and all is fine. Great service, quick delivery and correct part.

I first removed the icemaker service door by separating the door pins from the hinge sockets. Next, I removed a 1/4" screw from under the right side of the icemaker that retains the icemaker and a “U” plastic clamp. This clamp straps to the icemaker from behind. Then, after partially sliding the old icemaker out, I struggled somewhat decoupling the wire connector because it was frozen. After disconnecting the wire harness, I then removed the defective icemaker.
The next step was, with the same 1/4" ratchet wrench, I removed the 3 screws from the bracket on the underside of the icemaker. I then proceeded to attach the same bracket to the new icemaker.
Next, I connected the electrical connector at the right side. I struggled a little bit sliding the new icemaker in because the water cup assembly on the new part was taller than the old one and thus bumped into the water delivery tube.
You then reverse the procedure for installation.
Finally, before operating the icemaker I turn the icemaker switch on and turn off the power to the refrigerator for about one minute before turning it back on, while the freezer door was closed. Within 5 minutes, the icemaker was working properly and within 24 hours the ice bin had been filled.
Good Luck!

Unplugged appliance, removed both boards, 3 Phillips head screws in each, reinstalled new ones. Shortly after ice was coming.

Removed screws, took out the old one and put in the new one.

Popped the old one out with a kitchen knife and popped the new one back in. It tool less than 15 seconds!!

My owners manual said to unplug fridge from elec outlet, use a kitchen knife to gently pry off the switch plate
(manual had a pictoral example), unclip the two wire, replace with on new switch and replace the switch. Close
door and plug back in. Open door to check that the lite
works. Walla! It did. Thanks!

Sincerely, Ron Marshall, Billings, MT

replaced emitter and receiver

Used the instructions on your site.

Replaced sensors but still not making ice. Followed the Brown wire from the Water fill selenoid to the Ice Maker Module. Take the three screws off the Icemaker Gearbox and there was a severely Crusty Connection. It cleaned fairly well and Presto.....ICE!!!

I installed the 2 circuit boards. Real easy. Did not fix problem so going to have to check further.