Kenmore Dishwasher Legs and Feet

Your Price

$10.59

Kenmore Dishwasher Leveling Leg

PartSelect Number PS11770497

Manufacturer Part Number 5304506540

Sold individually.

Your Price

$7.27

Kenmore Dishwasher FOOT

PartSelect Number PS8728141

Manufacturer Part Number 00617585

Videos!

Your Price

$8.06

Kenmore Dishwasher Leveling Leg

★★★★★

1 Review

PartSelect Number PS261477

Manufacturer Part Number WD2X320

This leveling leg is located under the dishwasher cabinet. It is sold individually.

Your Price

$16.27

Kenmore Dishwasher FOOT

★★★★★

1 Review

PartSelect Number PS8728142

Manufacturer Part Number 00617586

Your Price

$55.10

Kenmore Dishwasher CASTER (4 PACK)

★★★★★

3 Reviews

PartSelect Number PS11746474

Manufacturer Part Number WP8559933

This includes all 4 casters.

Your Price

$31.30

Kenmore Dishwasher /Portable Washer Roller

PartSelect Number PS11741296

Manufacturer Part Number WP3370639

Your Price

$50.05

Kenmore Dishwasher Leveling Leg

PartSelect Number PS557020

Manufacturer Part Number 8193716

Leveling leg Now includes two different sizes. Use the one for your model. If you need two legs you will need to purchase a QTY of two of this kit.

Installation Instructions

Phil from Fairfax, VA

Water was leaking.

This unit was unique that whole motor assembly was held in its place by two plastic clip. The gasket had few rings that worked as place holder, although gaskets don't go bad often this model could be if it gets pulled alot and if motor assembly get pushed it will push up the gasket and cause a leak. Repair was simple, 1) take spray arm off from inside. 2) get under neath the dishwasher, take off wires so it would free up some room, pulled two plastic holder out, gently push the motor assembly up to the tub, 3) from inside the tub, pull up the assembly enough to get your hand under the gasket and pull them off. 4) Replace the gasket, align the assmebly and push down to snap in the gasket. 5) get under and push in two plastic clip back in, put wires back into its place. Back in the tub to push down the assembly again to make sure there are flush with surface. Put spray arm back on. Finished. Read more...