ApplianceMagic Chef Range


Level of DifficultyA Bit Difficult

Time to do repair15 - 30 mins

Age of Appliance1 - 4 years

Tools Nutdriver
Screw drivers

Peter J From Brooklyn, NY

Sep 28, 2007

20 out of 23 people found this instruction helpful

First I removed the oven door by pulling straight up off of the hinges in the open postion.
Next remove oven racks,then use 1/4 nutdriver to remove back screws on inside oven bottom plate.Next remove gold nut on silver tube @ pilot connection,then remove 1/4 nuts that hold pilot assembly.Next open top of stove and remove small gold nut "with the thin wire from pilot"attached to the back left of oven control knob.Snake that nut and wire from the top of the stove down to the oven and removethe whole pilot assembly. To install Carefully unroll the new pilot assembly starting from the oven "There are two round holes you need to snake the tube into"and up behind the back & into the stove top. Make your connection@ the oven assembly.Next attach the assembly with the 1/4 screws that you removed,then make your connection"gold screw silver tube" Now push in your oven control knob to alllow gas to flow to the pilot tube and check for leaks with a water @ soap solution. No bubbles no leaks. Light your pilot ....you must hold in the oven knob. Put back in oven plate,,,, 1/4 screws,,,,racks close the stove top ,Put door back on hinges and your done.....HOPE I HELPED,..Pete

Help other customers find the most helpful instructions.

Were these instructions helpful?

Diagrams and Parts List for this repair

Part PhotoPart DescriptionPriceAvailability

USE WPL 74010141 (Now subbed to USE WPL 74010141)

Part Number: PS2342142

In Stock