Average Repair Rating: 3.3 / 5.0, 1 reviews.
What's this?
Sort by:
< Prev
1
Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing installation instruction that matched.
Right front burner would not turn off.
Lifted stove top to disconnect burner wires in order to use stove until parts arrived. Remove a bunch of square drive screws to remove back panel from stove. Identify relay board and disconnect wire connectors from it then release several plastic clips and two screws holding board to oven. Install new board and connect wires, No other
... Read moreadjustments were required.
Read less
DENNIS from SIERRA VISTA, AZ
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Pliers, Screw drivers
2 of 2 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
< Prev
1
Next >
Questions and Answers
Ask our experts a question about this part and we'll get back to you as soon as possible!
3 questions answered by our experts.
Sort by:
< Prev
1
Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Al
December 8, 2019
After finishing a self clean cycle, our stove now will not stop heating a preset temp. Did the high temp cause this damage and is this the right part?
For model number EW30ES6CGS4
Hello Al, Thank you for the question. This is normally caused by a defective Temperature Sensor, PartSelect Number PS820208. You can also test the sensor to confirm it is defective. Testing the temperature sensor probe on your oven is easy. With the sensor at room temperature, measure the resistance between the two prongs at the end of the sensor connector. The resistance of the sensor should read approximately 1080 – 1090 ohms at room temperature. Hope this helps!
1 person found this helpful.
Was this helpful?
Thank you for voting!
Darrell
May 18, 2023
Hi, We cant get the bottom element to come on. The element works, I tried switching the leads from the top element and the element works fine. so im assuming its a relay board. But there is 2 boards at the back, Which one would it be that controls the bottom element.
Thanks
For model number EW30ES6CGS2 Electrolux
Hello Darrell, thank you for reaching out. We believe your range is having this problem because of the control board. We recommend you replace the electronic control board, part number PS2378973, to fix the issue. We hope this information is useful!
