Have you ever purchased from PartSelect.com before?
Thank you for helping make our site better.
PartSelect Number PS2378115
This kit includes the stripper arm and fill cup.
This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.
This part fixes the following symptoms:
This was a pretty easy repair...I removed the retaining screws and slid the assembly off its tracks. Disconneting the wiring hardness was a pain but after a few minutes I had that off (use gloves, it gets cold in the freezer after a minute)Once I had the unit completely out of the freezer the replacement part took only minutes to replace.Reversed the process putting the ice maker back in - a few hours later my ice buck was full again.Simple repair - well worth the effort.
Help other customers find the most helpful instructions.
Were these instructions helpful?
Had to widen screw access hole in motor frame enough to use the phillips bit with my 12V impact driver. That worked perfectly. It took an extra two hours of trying to break the screw free without stripping it and figure out what to do when it wouldn't budge. Once I got the screw out the fix went quick and the ice maker now works great. If you have a coroded screw go straight to the impact driver.
Sorry I didn't do the repair but my husband did. It took him about an hour and a half. He did have to take the main part of the ice maker out of the fridge and take a couple of pieces off t oslide the tabs from the stripper arm into place. It was great. Fixed the icemaker for $22.00 dollars with no service fee. I can't imagine what they would have charged me.
I had to disassemble the unit. After it was out I unpluged the wires and removed the broken ends of the stripper. Most of my time was spent figuring out how everything worked. I installed the new arm and slipped the unit back in place. It works perfectly. I could do it in under 30 minutes now. The cost savings is well worth the effort.
Instructions with the kit made it very simple to remove and install the new stripper arm.
Remove the old and put in the new
No trouble following directions sent but when putting it back together the sensor in the back became dislodged. .
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2017 , Eldis Group Partnership. All rights reserved.