| |
11 of 14 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:15 - 30 mins
ToolsScrew drivers
CustomerDennis from Lake Mills WI
Mixer made very bad grinding noise, and would skip while making bread dough
1, REMOVED TRIM PIECE (1 SCREW)
2, REMOVED COVER (4 SCREWS)
3, REMOVED SPEED SWITCH ASSEMBLY (2
SCREWS)
4, REMOVED GEAR COVER (4 SCREWS)
5, REMOVED AND EXAMINED 2 WORM GEARS FOR WEAR. GEAR COVER WAS BADLY CRACKED, DON"T KNOW IF IT WAS CAUSED BY A PREVIOUS REPAIR OR BY HEAT, AS OLD COVER IS PLASTIC.
RECEIVED NEW PARTS AND INSTALLED THEM,
2 BEARINGS, 2 WORM GEARS, 1 NEW COVER OF DIECAST METAL AND A NEW GASKET.
ALL REPAIRS MADE WITH A #2 PHILLIPS SCREW DRIVER.
MY WIFE THEN MADE BREAD, AND IT PREFORMED FLAWLESSLY.
|
3 of 4 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:30 - 60 mins
ToolsScrew drivers
CustomerStephen from Colorado Springs CO
Worm gear stripped.
Removed mixer motor housing by removing 5 obvious screws.
Removed plastic transmission cover by removing 4 obvious screws.
Down load parts exploded drawing from PartSelect.com
Found the worn part by the shiny teeth on the large gear.
Found the large worm gear on the drawing and ordered the gear, and associated bearings. Did not need the seal.
Removed worn part, assembled new gear and beargings in same manner as the worn part, and placed new part in mixer.
Replaced transmission cover gasket.
Repacked grease from transmission cover onto the new gear.
Replaced transmission cover (4 screws).
Replaced mixer motor housing (4 screws).
Replaced mixer trim band around the motor houseing joing. (1 screw).
Plugged it and and it works, good as new.
|
1 of 2 people found this instruction helpful
Parts Used
Level of DifficultyA Bit Difficult
Time to do repair:15 - 30 mins
ToolsScrew drivers
CustomerVincent J. from Hudson NY
Worn gears had to be replaced (second time)
the hardest part is removing the retaining ring (didn't buy pliers)after that it is very easy, remove ring, top gear, center pin, bottom gear,worm gear(was removed first)the grease is pretty nasty,clean off the old grease and put it all back the way it came apart,with new grease.And then PRAY !!!!!!! THANK YOU PARTS SELECT for your wonder smart staff.
|
1 of 2 people found this instruction helpful
Parts Used
Level of DifficultyEasy
Time to do repair:30 - 60 mins
ToolsScrew drivers
CustomerGary from Hamburg MN
Gears and bearing failure
inspected and replaced worn components
|
1 of 3 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:15 - 30 mins
ToolsScrew drivers
CustomerThomas from Upperco MD
Bevel gear, bearings and housing replacement
The parts I received from PartSelect were higher quality than the original parts. The bevel gear and housing were originally plastic. The new ones are solid metal. The machine sounds and runs better than it ever did. The drawings from the website made this really easy. This will be my first choise for parts from now on.
|