Have you ever purchased from PartSelect.com before?
Thank you for helping make our site better.
PartSelect Number PS11749476
Used in Mixers.
This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.
1, Removed trim piece (1 screw) 2, removed cover (4 screws) 3, removed speed switch assembly (2 screws) 4, removed gear cover (4 screws) 5, removed and examined 2 worm gears for wear. Gear cover was badly cracked, don"t know if it was caused by a previous repair or by heat, as old cover is plastic. Received new parts and installed them, 2 bearings, 2 worm gears, 1 new cover of diecast metal and a new gasket. All repairs made with a #2 phillips screw driver. My wife then made bread, and it preformed flawlessly.
Help other customers find the most helpful instructions.
Were these instructions helpful?
Removed mixer motor housing by removing 5 obvious screws.Removed plastic transmission cover by removing 4 obvious screws.Down load parts exploded drawing from PartSelect.comFound the worn part by the shiny teeth on the large gear.Found the large worm gear on the drawing and ordered the gear, and associated bearings. Did not need the seal.Removed worn part, assembled new gear and beargings in same manner as the worn part, and placed new part in mixer. Replaced transmission cover gasket.Repacked grease from transmission cover onto the new gear.Replaced transmission cover (4 screws).Replaced mixer motor housing (4 screws).Replaced mixer trim band around the motor houseing joing. (1 screw).Plugged it and and it works, good as new.
inspected and replaced worn components
took it apart. more grease all over. Put in all but one gear on the top. The noise is still there going to try to but the old bearings in and try again. I went back to the old worm gear and allmost all the noise stopped. I did put the new bearings in and the other gears. It seems that the gear on the worm gear was cut wrong. The noise was tear able. I tried the different parts I ordered one at a time. To find out which one stopped the noise. Every time I took a part I had grease all over. It took so long every time I put in a new part to put the trans back together again. I had grease all over.
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2017 , Eldis Group Partnership. All rights reserved.