Defrost Timer

PartSelect Number PS2072567

This refrigerator defrost timer will cycle for twenty-one minutes after every ten hours of run time. The defrost timer acts like a clock. It continually advances and alternates between activating the cooling cycle and the defrost heater.

This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.

This part fixes the following symptoms:

  • Fridge section too warm.
  • Freezer section too warm.
  • Freezer not defrosting.
  • Compare At

    $67.09
  • You Save

    $11.18
  • Your Price

    $55.91
In Stock
Fast Shipping Get this part fast. Average delivery time via regular ground: 1.8 days.

Videos For installing this part.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 4.3 / 5.0, 3 reviews What's this?
1-3 of 3
 

40 of 52 people found this instruction helpful

Parts Used

Level of DifficultyReally easy

Time to do repair:Less than 15 mins

ToolsNutdriver, Socket set

CustomerDale from Ligonier IN

Maytag refrigerator - fridge compartment was not cooling and the freezer compartment seemed to be cooling okay

Maytag Refrigerator (new 1991): First I unplugged the refrigerator from the electrical receptacle. I then removed the front grille and used a nutdriver to remove two small screws and unplugged the defective defrost timer. I then plugged the new defrost timer in, reinstalled the two small screws, reinstalled the front grille, and finally, plugged the refrigerator into the electrical receptacle. This took less than 15 minutes to complete. Please note, you may need to manually defrost the refrigerator, at least 8-10 hours, in order for the new defrost timer to have a fresh start of a defrosted fridge.
Frigidaire Freezer (new 2005) - Replacing the Drain Pan: First I unplugged the freezer from the electrical receptacle. I then removed the four bolts holding the compressor in place using a socket and ratchet. Then I carefully pulled the compressor out of its compartment to where I could easily get to the broken drain pan. I removed the broken drain pan and installed the new drain pan. Carefully pushing the compressor back into its compartment, reinstalling the four bolts. Plugged the freezer back into the electrical receptacle. Please use caution as the compressor may be hot and being careful not to kink any of the lines connected to the compressor. This project of installing a new drain pan took me about an hour to complete. Good Luck

Help other customers find the most helpful instructions.

Were these instructions helpful?

26 of 33 people found this instruction helpful

Parts Used

  • Defrost Timer

Level of DifficultyReally easy

Time to do repair:Less than 15 mins

ToolsNutdriver

CustomerLeon from Chaparral NM

Would not exit defrost mode (continual defrost)

Unplug the refrigerator. Remove face plate located in the upper back of the refrigerator compartment. Remove face place bracket on the right using nut driver. Removing these screws also frees the metal case enclosing the Defrost Timer. Pull the case away from the back of the refrigerator exposing the Defrost timer. Remove the electrical plug from the Defrost Timer. Then remove the Defrost Timer from the case by removing the two screws securing it. Reverse the procedure to install the new Defrost Timer.

Help other customers find the most helpful instructions.

Were these instructions helpful?

27 of 40 people found this instruction helpful

Parts Used

Level of DifficultyEasy

Time to do repair:30 - 60 mins

ToolsScrew drivers, Socket set

CustomerAnthony from Broadview IL

Refrigerator not cooling

My repair honestly was fairly simple, using the break down drawings i caputred on this site. all the components i purchased here, fit properly in the spaces provided for them ,upon restarting my refrigerator after assembling it workrd properly for about 2 week, then i discoverd a new problem, which has nothing to do with the parts i replaced, but i believe before i ever ordered any parts,my wife had a repairman come out to service it, that the part he installed was defective, not to mention he over charged me close to 400% FOR A PART I COULD HAVE GOTTEN ON THIS SITE FOR MERE DOLLARS, and the labor was totally ridiculous in cost. never again was my initial thought and never again it is , the part i have on order now is the heater tempt assembly that was installed that i am sure will take me no more than 15 minutes if that to do myself, with the other new components, i am anticipating my frige working fine, this should keep my evaporator coils from icing up and allowing the air to circulate and keep both my frieezer and fresh food compartments at the correct tempts.all components purchased and the one on order still comes out to less than what i paid a repairman to service my fridge with the installation of only one part that isn't doing its job.

Help other customers find the most helpful instructions.

Were these instructions helpful?

1-3 of 3