2068533-1-S-Whirlpool-67004704-Adaptive Defrost Control Board
2068533-1-S-Whirlpool-67004704-Adaptive Defrost Control Board 2068533-2-S-Whirlpool-67004704-Adaptive Defrost Control Board

Adaptive Defrost Control Board

PartSelect Number PS2068533

It allows the unit to enter a defrost cycle only when it is necessary.

This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.

This part fixes the following symptoms:

  • Fridge section too warm.
  • Compare At

    $280.44
  • You Save

    $46.74
  • Your Price

    $233.70
Fast Shipping Get this part fast. Average delivery time via regular ground: 1.8 days.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 4.2 / 5.0, 3 reviews What's this?
1-3 of 3
 

19 of 23 people found this instruction helpful

Parts Used

Level of DifficultyEasy

Time to do repair:15 - 30 mins

ToolsNutdriver, Socket set

CustomerEugene from Bakersfield CA

Refrigerator was not getting cold

For the defrost control board, it is a really easy replacement on my model Maytag refrigerator, all you have to do locate the freezer/refrig, cooling controls in the main part of frig and remove the control knobs by pulling them of by hand, for the cover use 1/4 socket with a socket wrench or socket screw driver to remove the cover, after that you will see a panel cover that you have to unclip by hand and that is where your control board is located and at this point it's just plug and play. just reassemble in reverse order. I changed my overload relaywith start capaciter out also when I changed my defrost control board. To change the relay out, first remove the lower panel on the rear base of the frig. and this is where you will find the relay pluged into the round black compressor, simply unplug the old and plug the new in, it's just that simple!

Help other customers find the most helpful instructions.

Were these instructions helpful?

3 of 4 people found this instruction helpful

Parts Used

  • Adaptive Defrost Control Board

Level of DifficultyReally easy

Time to do repair:Less than 15 mins

ToolsSocket set

CustomerDaniel from Bellflower CA

Fridge side not cold when freezer is blasting cold

I knew it was either the thermostat or defrost control board. Checked resistance with multimeter across the thermostat and heater element. Both check out ok so I replaced the board and all is good. Board on my model was in the controls panel.

Help other customers find the most helpful instructions.

Were these instructions helpful?

3 of 6 people found this instruction helpful

Parts Used

  • Adaptive Defrost Control Board

Level of DifficultyEasy

Time to do repair:15 - 30 mins

ToolsNutdriver

Customerbrandt from sycamore GA

Fridge was not cooling and staying around 50 degrees. Freezer was cooling normally.

Looked on web to see problems with same model. Recieved new board, unplugged fridge,took off cover inside fridge top left,took old board out, unplugged wires from old board and plugged new board in, installed cover and plugged fridge into wall outlet.

Help other customers find the most helpful instructions.

Were these instructions helpful?

1-3 of 3