10 of 11 people found this instruction helpful
Level of DifficultyReally Easy
Time to do repair:Less than 15 mins
ToolsPliers, Screw drivers
CustomerWilliam from Marion, WI
Water was sprating all over the inside of wash machine onto the circuit board.
I took the two screws off the back that holds the top down, lifted it , then pulled it back to remove. After this was removed, there were two more screws holding down the assy-s housing and drawer. First remove drawer where you add the soap and softners. Then I pulled that back and the assy-s housing drawer just snaps onto the housing. I pulled the drawer off, then I took the four hoses that are connected to the back and put on the new one in their respected spot. I snapped it back on and reassembled. You don't need a maytag repair man to do this job.