Models
>
WF316BAW
WF316BAW Maytag Washer - Overview
Sections of the WF316BAW
[Viewing 7 of 7]
.gif "SUPPLEMENTAL INFORMATION Diagram and Parts List for Maytag Washer")
Keep searches simple, eg. "belt" or "pump".
Hose Clamp
PartSelect #: PS11743008
Manufacturer #: WP596669
This hose clamp is used in a wide variety of household appliances. Most often it is found in washers, dishwashers, refrigerators, freezers, dehumidifiers, garbage disposals, or air conditioners. This ...
$11.80
In Stock
Door Lever
PartSelect #: PS11741552
Manufacturer #: WP34001260
Also known as a door strike.
$68.46
In Stock
Hose Clamp
PartSelect #: PS11740613
Manufacturer #: WP285655
The hose clamp is used to hold the water hose in place which will prevent the hose from leaking water. Sometimes the clamp may lose its ability to latch on, causing a leaking washer. For the installat...
$11.10
In Stock
Drain Pump Assembly - 120V 60Hz
PartSelect #: PS4204638
Manufacturer #: DC31-00054A
This is a 120 volt, 60 hertz drain pump assembly for a washing machine. It is a genuine OEM part. This pump helps expel water from the washing machine, and is activated after the spin speed is maintai...
$181.80
In Stock
Leveling Leg with Rubber Foot
PartSelect #: PS2037271
Manufacturer #: 34001341
Sold individually.
No Longer Available
Shock Damper - Front
PartSelect #: PS11741563
Manufacturer #: WP34001303
This part helps keep the washer from vigorous shaking during its cycles. They are sold individually. They mount to the front half of the outer tub. Appliance would take 2.
$95.15
In Stock
Door Switch Assembly
PartSelect #: PS4210737
Manufacturer #: DC64-00519B
This is a door switch assembly designed for Samsung washing machines. This door switch assembly is used to latch and lock the door shut before the washing cycle commences and communicates with the con...
$34.13
In Stock
Door Boot Seal
PartSelect #: PS2037232
Manufacturer #: 34001302
Also known as a bellow. This part is used to keep the clothes inside the tub during the wash cycle. The folds in the bellow allow the tub to move separately from the door during the spin cycle.
$261.92
In Stock
VALVE-WATER;V-0117,NYLON
PartSelect #: PS4209100
Manufacturer #: DC62-30314K
One solenoid valve for hot water
$89.85
In Stock
Drain Pump with Bracket
PartSelect #: PS11741564
Manufacturer #: WP34001320
This pump helps expel water from the washing machine and is activated after the spin speed is maintained for a specific period of time.
$376.72
In Stock
Questions And Answers for WF316BAW
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Common Symptoms of the WF316BAW
[Viewing 5 of 5]Lid or door won’t close
Fixed by
these parts
these parts
Show All
Leaking
Fixed by
these parts
these parts
Show All
Will not drain
Fixed by
these parts
these parts
Show All
Will Not Start
Fixed by
these parts
these parts
Show All
Burning smell
Fixed by
these parts
these parts
Show All
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
door latch split
replaced door latch but door would not close had to remove latch assembly and reset the latch in the latch assembly. To reset latch in latch assembly you remove the black plastic only on latch assembly then press the spring down with thumb move the black plastic catch back to the latch position. when you remove the black plastic there is
... Read more
four metal switchs and one spring that you have to pay attention too so remove very carefully.
Read less
Parts Used:
-
Leon from North Platte, NE
-
Difficulty Level:Very Difficult
-
Total Repair Time:1- 2 hours
-
Tools:Pliers, Screw drivers
50 of 63 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
A small coin had entered the impeller and the blades ground off against it.
The rear access is attached with 2 Phillips head screws, which I removed.
The drain hose is held up with a similar screw.
I removed the screw and drained the hose into a bucket.
Then I just removed the connector and hoses with my fingers, removed the three 1/2" bolts holding the pump in place, changed the pump and put every ... Read more thing back together. Works like a champ. Quick and easy fix.
My only negative comment is that I only needed the impeller, but had to buy the complete pump assembly. Other than that, all fine.
The drain hose is held up with a similar screw.
I removed the screw and drained the hose into a bucket.
Then I just removed the connector and hoses with my fingers, removed the three 1/2" bolts holding the pump in place, changed the pump and put every ... Read more thing back together. Works like a champ. Quick and easy fix.
My only negative comment is that I only needed the impeller, but had to buy the complete pump assembly. Other than that, all fine.
Read less
Parts Used:
-
CHARLES from MAGNOLIA, TX
-
Difficulty Level:Really Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Screw drivers, Wrench set
46 of 56 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Broken glass door on front load waher.
Never thought that the glass would break like it did. Removed the whole door assembly and took out the screws that hold the plastic retaining ring for the glass door. Replaced glass and reassembled the door. Very easy repair. Took about 15 min.
Parts Used:
-
cheryl from commerce city, CO
-
Difficulty Level:Really Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Screw drivers
21 of 25 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!