39 of 60 people found this instruction helpful
Level of Difficulty: Easy
Time to do repair: 30 - 60 mins
Tools: Nutdriver, Pliers, Screw drivers, Wrench (Adjustable)
Customer: Don from Elma, IA
Dryer would'nt start / drum wouldn't turn
Unplugged Dryer; used screwdriver to push in and release two clips that hold top to front, tilted top back and removed two screws holding front to sides. Disconnected door switch and removed front .
Reached in above motor to remove belt from around pulley and tensioner wheel, Pulled drum and belt out of machine.
Removed approximately 10 screws around perimeter of blower housing and removed cover to access blower wheel. Removed outer lock ring from shaft and clamp from blower wheel hub, and removed blower wheel.
Took out tensioner assembly.
Disconnected wiring connector from motor.
Removed three screws that held blower housing to bottom and removed retainer around rubber motor mount at pulley end of motor. Lifted out motor, blower housing and vent pipe as one unit.
Removed 2nd outer lock ring from motor shaft.
Rotated motor frame 45 degrees to free the rubber mount from the blower housing.
Screwed new pulley onto new motor shaft and cleaned blower housing and vent pipe.
Assembly is reverse of disassembly.
Inspected and lightly greased the glides and inspected the idler wheels before reinstalling drum.
Dryer works perfectly.
Five to ten minutes also spent unscrewing and replacing timer knob and hinge pins on lid of matching washer Crosley cw22b5v.
Very simple repair.
12 of 24 people found this instruction helpful
Level of Difficulty: Really Easy
Time to do repair: Less than 15 mins
Tools: Screw drivers, Wrench (Adjustable)
Customer: Raul from cypress, CA
Broken pulley and belt
Before anything else, I would like to thank your company for a quick response and fast delivery of the parts that I ordered. Ordering parts from your company saved me a lot of money. The repair took me about 15 min. First I removed the two screws that hold the front cover and then I pulled out the drum and replaced the broken pulley, then I put back the drum and the belt in place and then I put the cover and screwed back in and now I'm back washing and drying pile of clothes.