Have you ever purchased from PartSelect.com before?
Thank you for helping make our site better.
PartSelect Number PS1957416
This condenser fan motor kit includes a motor, fan blade, wire harness, and screws. Used in a refrigerator, the condenser fan motor moves the condenser fan blade to direct and move air across the condenser coil. Please note: The manufacturer has changed the appearance of the product from the original. The kit still functions the same as the original part. It is an OEM factory replacement. Make sure to unplug the refrigerator from the power source and wear gloves to protect your hands. Also, a helpful tip is to store food to prevent deterioration when the power is off.
This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.
This part fixes the following symptoms:
I have a grandson that works for Pantex. He replaced the fan and motor in less than ten minutes using only the nutdriver tool. My cost compared to local supplier and labor was about 75% less.
Help other customers find the most helpful instructions.
Were these instructions helpful?
remove the condenser fan mounting bracket, install new motor on bracket, then install bracket in refrigerator. Only issue is the smaller your hands the better, it is a tight fit, but not too hard to do. The evap fan motor is behind the back wall of the freezer. Empty the freezer and remove the back panel. Remove the fan blade and pull the 3 connections loose. Replace the bad motor with the new one, connect electrical connections back up and you are done. All parts were in stock and shipped in 3 business days. This is the second time I have used this site for repairs, I highly recommend them for any appliance repairs.
Removed the cardboard baking on back. Unplugged the fan. Used 1/4 socket and removed the 3 nuts. Removed the fan. It is tight quarters. Take your time and the job will go fast.
I had let the Refrigerator sit out in the garage unplugged and the temperature in the garage fell below freezing and the Water Inlet Valve froze and busted. The refrigerator is 14 yrs old and had plastic nut fittings on the water lines that connected to the solenoids , just had to take a knife and cut the tubing to remove the nuts and push the water tubes into the new solenoids on the Water Inlet Valve. took about 15 min. very easy. This is a good place to get parts.
First let me say that the instructional video on your website for this repair was very informative. My son and I watched that before we began the repair. We unplugged the unit first. After removing the back cover, he unplugged the old fan's electrical connection, and then proceeded to remove the fan and bracket from the unit. We then removed the old fan from the bracket, installed the new one and then he reinstalled the new fan and bracket back into the unit. He used the included electric adaptor cable to complete the electrical connection, plugged in the refrigerator briefly to confirm all was well (it was), then replaced the back cover and we were done.
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2017 , Eldis Group Partnership. All rights reserved.