Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing reviews that matched. Try using some different or simpler keywords.
★★★★★
★★★★★
MIKE F - June 21, 2020
Verified Purchase
Easy repair
The right part it worked great saved me $150
< Prev
1
Next >
Questions and Answers
Ask our experts a question about this part and we'll get back to you as soon as possible!
3 questions answered by our experts.
Sort by:
< Prev
1
Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
John
May 29, 2019
My oven does not warm at all. I have checked the continuity of oven heating elements and both seem fine. When i set the oven to bake, the display will stay at 100, and oven makes a slight clicking sound every so often but elements stay cool. Microwave works well. Is it likely that the control board is the culprit?
For model number JKP90SM2SS
Hello John, Thank you for the question. I suggest testing the Temperature Sensor, PartSelect Number PS10059162. Testing the temperature sensor probe on your oven is easy. With the sensor at room temperature, measure the resistance between the two prongs at the end of the sensor connector. The resistance of the sensor should read approximately 1080 – 1090 ohms at room temperature. If the sensor is good you may need to replace the control board. Hope this helps!
The led display is no longer bright enough to be seen easily. Is this the correct replacement assembly? How difficult is this to replace?
For model number JKP90WM2WW
Hello Mitch,
Thanks for your question. Yes, this is the correct control board for your model and should resolve the issue you are having. You will need to remove the display assembly to access the board but that is not very difficult to do overall.
I hope this helps.
1 person found this helpful.
Was this helpful?
Thank you for voting!
Daniel
August 20, 2021
The oven display shows 100 and makes a clicking sound but will not heat up. The temp probe and both heating elements have been changed will this control board fix this problem
For model number JKP90BM2BB
Hello Daniel, Thank you for writing. You may want to recheck that the controller is hooked up correctly. There is a chance that the lower oven harness is connected to J4 and the upper oven harness is connected to J3. If this doesn't fix it then, you can change out the board. Good luck with your repair.
Was this helpful?
Thank you for voting!
< Prev
1
Next >
✖
Ask a Question
Ask our experts a question on this part and we'll respond as soon as we can.