Have you ever purchased from PartSelect.com before?
Thank you for helping make our site better.
PartSelect Number PS11744641
This bake element is found on the bottom of the oven.
This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.
This part fixes the following symptoms:
1. Locate range breaker and switch off.2. Verify range has no power by switching fan or light on.3. Have someone shine flashlight beam on inside back of oven.4. Use screwdriver to remove two screws holding outer element to back of oven wall.5. Carefully pull element out until wires attached to ends of element can be seen.6. Pull connectors off ends of element, don't let them pull back into the insulation material.7. Connect new element to wires.8. Push element back into position and re-attach the screws.9. Make sure that the element is resting nicely on the floor of the oven.10. Reset the range breaker and test the oven.
Help other customers find the most helpful instructions.
Were these instructions helpful?
Took out two screws, threw the old one away, and put the two screws back in. Then washed up.
plugged it in screwed it in placed grease filter in place DONE 3 minutes tops piece of cake!!
Really easy!! Cut off Breaker so the Range had no power. Use phillips head screwdriver, remove the two screws holding the bake element in. Remove connectors from element. I put (heat shrink) wrap around the female connectors then attached them to the element, heated the shrink wrap, replaced the screws and cut on the breaker / power. Turned on the oven (350) to "bake" off the oil film off of the element. (Element will smoke / smell for a few minutes).
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2016 , Eldis Group Partnership. All rights reserved.