This is cookware designed for use in your range or oven. It is a two-piece dish that is used to grill or cook food while the broil function is on, meaning it can withstand high temperatures. This set ...
The temperature sensor is a part for the oven, on your range. This temperature sensor has a body length of just over 3 inches. The purpose of this part is to measure the temperature within the oven an...
The hinge kit, or oven door hinge, is used in ranges and wall ovens. The hinge attaches to the right side of the door and controls how fast the door opens. At a specific angle, it allows the door to r...
Really easy but in this model there are 2 versions of the sensor, male and female. The website didn't have any place to see that. So the first sensor that came was male but we needed the other. After calling they sent me a return form and sent the new part (which was actually much cheaper) overnight and it went in very quickly. Would che
... Read moreck this out again when anything went wrong. they are great folks to work with.
TURN OFF POWER TO RANGE AT FUSE BOX -- a)Open the oven door, b) Unscrew the left and right silver nuts (not the black screws)that are in the oven under the control panel, c)pull off the four control knobs on the control panel, d) gently tilt out the control panel, e) set the control panel in/on the protruding arms, f) pull off THE connect
... Read moreors at the back of the switches - remember which is top and bottom, g) use a screw drive to break off the plastic pieces that hold the switches in place, h) push out the old switches, i) push/snap in the new switches, j) reconnect wires, replace control panel and screw in the nuts.
1. Locate range breaker and switch off. 2. Verify range has no power by switching fan or light on. 3. Have someone shine flashlight beam on inside back of oven. 4. Use screwdriver to remove two screws holding outer element to back of oven wall. 5. Carefully pull element out until wires attached to ends of element can b
... Read moree seen. 6. Pull connectors off ends of element, don't let them pull back into the insulation material. 7. Connect new element to wires. 8. Push element back into position and re-attach the screws. 9. Make sure that the element is resting nicely on the floor of the oven. 10. Reset the range breaker and test the oven.
