Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing reviews that matched. Try using some different or simpler keywords.
★★★★★
★★★★★
Gregory R - June 1, 2023
Verified Purchase
Worked as expected
Correct part. Looks great
★★★★★
★★★★★
Anne B - November 21, 2018
Verified Purchase
Great part
easy install and made my fridge look new again!
★★★★★
★★★★★
Jose S - June 29, 2018
Verified Purchase
Easy repair and quick
Part was easy to install
★★★★★
★★★★★
Gary M - April 24, 2018
Verified Purchase
Easy fix. Looks great!
Part came sooner than expected! Perfect fit!
★★★★★
★★★★★
Maryann D - April 19, 2018
Verified Purchase
Web site easy, ordering was easy and shipment/delivery on time.
part was just as described and of good quality.
< Prev
1
Next >
Customer Repair Stories
Average Repair Rating: 2.5 / 5.0, 1 reviews.
What's this?
Sort by:
< Prev
1
Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing installation instruction that matched.
2 Problems: Ice Dispenser dead and Water Dispenser dead
From Google to PartsSelect. Reading the forum, the consensus was that to fix the nonworking dispensers the main refrigerator motherboard had to be replaced. I ordered it which is easy to do because the diagrams show all the parts clearly. Great website. I also ordered the front trim piece because I had snapped one of the prongs holding it
... Read more on. They arrived quickly. The trim just snaps on the front which takes a few seconds. The motherboard which is just a circuit board, even came with replacement instructions. It takes a few minutes to wheel the refrigerator out, then take off the back panel (3 screws), unplug all the connectors, unsnap the circuit board, snap the new one in, plug the connectors in, reattach the back panel, and wheel the refrigerator back to the wall.
The water dispenser promptly froze up. To make sure that it is not the solenoid valve, unhook the water hose under the freezer door. Pressing in the water dispenser should pump water out of the hose onto the floor. It did for me. Since there is only plastic tubing after that, it has to be clogged with ice. I took a thermocouple, inserted the wire into the water dispenser outlet, it would only go in about 3 inches and displayed 31 F. I took a plastic funnel which slipped onto the end of the outlet and used a blow dryer to heat up the outlet a lot several times. Eventually the ice unfroze and it has been working ever since. I think if this happens again, I'll get a cheap aquarium aerator to pump air, for the hours it might take, through a thin tube (using wire insulation) to the frozen spot to melt the ice.
While the refrigerator was away from the wall, I took off the screws holding the large bottom panel in the back off. This exposes the condenser cooling which visually needed to be cleaned off with a vacuum cleaner. After doing this, it seemed to make the refrigerator run much more efficiently.
The refrigerator has been working perfectly for past month and it makes me so happy.