Below is a list of all parts for the General Electric Refrigerator ZISW48DSE. To find the repair part you need, you can browse the list below or you can narrow your choices by searching for a part by name or description.
Replacement icemaker kit - electronic. This kit includes a 4 pin round plug-in connector, 6 post plug-in connector, tube and fill cup.
This valve comes with 1/4" compression inlet.
NOTE: This part comes with new quick connections. To install - cut retaining nuts off of existing plastic water lines and gently push them into new valve. To remove - depress ring that the tube slides into.
This kit includes 1 cube solenoid, 1 armature, 2 tooth washers and 2 1/4 hex head screws.
This auger and bucket assembly is used on 25 cubic feet and 27 cubic feet side by side models.
The start relay briefly boosts the compressor, and then shuts off as soon as the motor gets up to speed.
Found at the end of the auger in the ice container - replace when the icemaker doesn't dispense ice.
This fill tube grommet is used on the icemaker.
This is a decorative front cover that is made of plastic that covers the opening to where the icemaker is located and disables contact by the user while the icemaker is engaged.
This refrigerator defrost timer will cycle for thirty minutes after every ten hours of run time.
This part comes with 3 round pin connection terminals.
This fan motor circulates the air through the refrigerator grille and cools the compressor and condenser coils. It also helps...
This ice bucket auger kit come with an auger and a blade. Please note: As per manufacture the part shown in the picture is no longer available. The updated helix coil is now approximately 5". If you currently have the original part you will need to order the complete auger/bucket assembly.
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2015 , Eldis Group Partnership. All rights reserved.