Quick Question!

Have you ever purchased from PartSelect.com before?

Models > ZISW42DWA > Parts

ZISW42DWA General Electric Refrigerator - Parts

All parts for the General Electric Refrigerator ZISW42DWA

Below is a list of all parts for the General Electric Refrigerator ZISW42DWA. To find the repair part you need, you can browse the list below or you can narrow your choices by searching for a part by name or description.

All Parts for the ZISW42DWA
1-14 of 309
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$7.36

Dispenser Door Assembly or Flapper

The dispenser door assembly (or flapper) is what opens to release the ice once the lever has been pressed. This part mounts in the ice dispenser. The cranker no longer comes with t...

$155.85

Ice Maker

This is a replacement ice maker kit, it is used in the freezer section of your refrigerator. This particular model will produce seven round or crescent shaped cubes every cycle. The ideal temperature of a freezer is zero degrees Fahrenheit. If the temperature in your freezer is at an appropriate level and ice is still not being made it could be an issue with the water inlet valve or your ice maker assembly. If you determine it is the ice maker, this is the replacement you need. This kit includes a set of installation instructions, a 4-pin round plug-in connector, 6 post plug-in connector, tube and fill cup. Before you start this repair, you should shut off the water supply and unplug your appliance. Please note, when you have installed your new ice maker it can take up to 24 hours for it to begin producing ice.

$3.46

SWITCH LIGHT

The interior light of your refrigerator is controlled by a switch that is activated when the door is opened and closed. If your refrigerator light will not turn on, there could be ...

$38.45

Dual Inlet Water Valve

This valve comes with 1/4" compression inlet. NOTE: This part comes with new quick connections. To install - cut retaining nuts off of existing plastic water lines and gently push them into new valve. To remove - depress ring that the tube slides into.

$10.71

Water Tube Union - 5/16" x 5/16"

Sold individually.

$163.83

Auger and Ice Bucket Assembly

This auger and bucket assembly is used on 25 cubic feet and 27 cubic feet side by side models.

$92.33

Dispenser Control Board - 2 Slide Switches

It is used with those refrigerators that have an ice and water dispenser in the door.

$69.13

Crushed/Cubed Ice Solenoid Kit

This kit includes 1 cube solenoid, 1 armature, 2 tooth washers and 2 1/4 hex head screws.

$55.58

Defrost Timer - 120V 60Hz

This defrost timer will cycle for 25 minutes after every six hours of run time. The timer itself is made of plastic, and its terminals are bent, the leads are internal, and the lab...

$8.63

Actuator Pad

Note: This part is now ONLY available in black.

$4.12

SCREW

$11.69

Ice Dispensing Drive Cup

Found at the end of the auger in the ice container - replace when the icemaker doesn't dispense ice.

$54.19

Dispenser Door Solenoid Kit

This kit is used on the water/ice dispenser door. This part allows water/ice to be dispensed on demand.

$0.43

SCR 8-18 AB IHXW 9/16 S

This is a self-tapping sheet metal screw and is used in conjunction with multiple appliances in your household. This part is size eight and has 18 threads to the inch. The AB in the name indicates that it is a self-tapping screw with sharp points and fine threads. This part has a hexagonal head with built in washer, but is often referred to as simply a hex head. This screw is 9/16 inches in length. This piece is sold individually.

All Parts for the ZISW42DWA
1-14 of 309