ZFSB25DMASS General Electric Refrigerator - Instructions

per instructions supplied with main electronic control board. was much easier than I thought it might be.

Ice maker was side mount instead of rear mount as shown in previous insructions. Removed one screw and slide ice maker forward. used flat head screw driver to undo the ice maker plug. The ice maker came right out. Removed old ice maker fill cup and put it on the new ice maker. Slide the new ice maker into place and used the same screw to secure it. Pluged it in and turned on the ice maker. Had new ice in a couple of hours. It comes with a round plug to square plug adapter, new fill cup and fill tube, all of which I didn't use.

Only needed to remove one screw, slide unit out and disconnect the power cord. Theb reverse the above operation to install the replace ice maker unit. Quick and extremely easy....

Used a small screw driver to remove the damaged switch. Carefully unhooked the two wires and hooked the wires to the new switch. Pushed the new switch into place. Be careful that the wires do not pull back into the refrigerator wall. Took about 15 minutes. Works like New. Easy fix.

Had to remove all the covers and fans to expose the condenser, which was difficult as the parts were frozen to it. The styrofoam covering the condenser made it almost impossible to defrost it. Therefore, I ripped the styrofoam off to expose the condenser. Was not really difficult to fix the styrofoam cover using metal tape. Replaced temperature sensor in aluminum block, and used butyl sealant to secure. Had to also re-install parts of ice-ball kit that were not well covered. Lots of parts to keep track of, but anyone could do it.

took 1 screw out and removed ice maker and slid new one in and replace screw and connected power cord

First determined my modle did not require any of the wire mods descibed on the instructions. Removed power and three cover plate screws. Removed board connectors. Calapsed board anchors and removed board. Removed existing ground wire from board. Installed ground wire on new board and installed board on four mounts. installed connectors and replaced cover and screws. I did wear playtex gloves so as not to cause a static short and wipe out the new board. Took off the bottom panel and cleaned condensor fan cage while I had the fridge out. Secured, plugged in fridge, works real fine, lasts a long time.

As described by you

As the video showed me. This was very helpful.

watching your vedio it was very easy to replace. I stop it and completed one part at a time .

Followed the instructions, which were clear.